Screen Printing beginner's mistakes and how to avoid them !

[@Almightees70]

Very good video!

[@melwilliams273]

Not enough people mention the off-contact distance. I couldn't figure out why my first few prints kept smudging. Then, a KZbinr casually mentioned "Off-Contact" and I looked into it. Once I corrected that, I didn't have a smudging issue anymore.

[@begoodornotobe]

Super! je dois également m’équiper en petit matériel et je m’inquiète de cela. Donc quels sont tes conseils à ce sujet @melwilliams ? Merci

[@Britpop-Tribute-Band]

Thanks for that. I found this video that explains off-contact kzbin.info/www/bejne/Y17XiH2PjL6an68

[@tiboruc8110]

very helpful thankyou

[@roldandescamps4183]

Great video ! Thanks for the tips !

[@sramdeojohn4428]

👍

[@Britpop-Tribute-Band]

3:43 How come you're not FLOODING first and then doing one single sweep?

[@MekanikaTools]

Hello, This is actually Will’s method. Martin typically follows the same approach as you mentioned-flooding first, then sweeping once. You can check out this video for reference: kzbin.info/www/bejne/fn6viJueobh5fqs

[@williamdedecker3464]

First !