Scx24 Injora Stamped Steelies, How to assemble

Hi
Sharing a simple method on how to assemble stamped steel beadlock rims.
I used the new Injora offset stamped steel rims and the Injora 58mm crawler masters :)
I used Pro-line Hyrax undersized soft foams. Stock foam is a bit too hard. Can be also used if it is cut to soften it.
Rims: www.injora.com/products/4pcs-...
Tires: www.injora.com/products/4pcs-...
-------------------
Get 5% OFF at Injora.com
Use code: DemoMCC05
-------------------
My current build:
Injora upgrade parts
(steering knucles, steering links, servo adapter, servo arm, 050 66T motor, plate, carbon chassis, brass beadlock rings, brass hex adapter, beadlock rims, double barrel shocks, 13T OD gear)
Esc: ASX24-Crawler
www.modellbau-regler.de/shop/...
Tires: Injora 58mm Crawler Master + Hyrax foams
Battery: Turnigy 2s 35-70c 300mah 17g.
Have fun 😉
-------------------

[@aarontowle9486]

Thank you finally someone that could help me. Liked the video cheers

[@orrc16]

Really beautiful 😍 i love this tires 👍😉

[@demomicrocrawlerclub]

Thanks mate :)

[@YOOPDLRC]

Injora Stamped Steelies 👍😎👍 It's Great !!!!!!!

[@demomicrocrawlerclub]

Love them too :)

[@Elisplushies360woodierc]

I have same tires but different injora wheels. The bead always pop out when i out. Any issues with yours?

[@demomicrocrawlerclub]

Hi. I had no issues with it. The bead never came out. Which rims r u using?

[@jayf2487]

Can these be flipped to deep dish just like rc4wd?

[@demomicrocrawlerclub]

No but it is also not needed. These are designed to be deep dish already. It has a negative offset. It gives a track width of ~112-113mm. If you flip these, track with will be less. It is good as it is :) If you flip regular stamped steelies that gives around ~120mm track width.

[@makoskid]

What size screws, 1.5, 1.3?

[@demomicrocrawlerclub]

:D M1.4 screws with m1.3 hex head

[@saanho-lee9364]

Are these waterproof?

[@demomicrocrawlerclub]

Hey. If you mean the material, i would say yes and no. Also did not test it with water, but if you mean if it will get rusted if you run in water, it will. If you mean if water goes into it, i would say no(if you well fit it), unless you vent it. I do use only vented wheels.Means you drill a hole onto the rim or tire so air can get in.

[@christopherduby5330]

The company should not be tightening them down extremely tight since you need to loosen them to install the wheels and tires

[@demomicrocrawlerclub]

I had no issues like you mentioned. Maybe it was a mistake.

[@christopherduby5330]

This company has sent my friends and I a few sets of wheels that were way too snug and wouldnt come out. Unhappy with them

[@demomicrocrawlerclub]

I don't really understand your problem. What do you mean it was snug? And wouldn't come out? This doesn't make sense for me. Maybe my English... I did not experience any issue with their rims. Got 3 set of different rims from them.