Peugeot 106 Front wheel bearing

  Рет қаралды 16,365

Seaside Garage

Seaside Garage

Күн бұрын

Пікірлер: 34
@2OO_OK
@2OO_OK 3 жыл бұрын
Great video. You are one of very few you tubers who knows which bearing race to push on and when. So many other videos demonstrate how to damage a new bearing. Well done and thank you.
@SeasideGarage
@SeasideGarage 3 жыл бұрын
Thank you.... Thats a pretty important thing to do right, unless you really enjoy to change them... ;)
@oggy4418
@oggy4418 2 жыл бұрын
9:45 using the grinder is the last option I did it many times. Two mounting levers from your workbench and some nuts or peaces of something to put under to create a strong leverage are all you really need. I was always surprise how easy it went off.
@proovemewrong
@proovemewrong Жыл бұрын
Thank you for taking the time to make this video 😊
@asc556
@asc556 6 ай бұрын
Great video. Question: my 106 start to do a high pitch noise at speeds above 50km/h. Could it be the front wheel bearing? Cheers.
@jeffreylunger
@jeffreylunger 2 жыл бұрын
That strut looked surprisingly easy to handle and carry. A benefit of working on smaller cars, I guess.
@SeasideGarage
@SeasideGarage 2 жыл бұрын
yup... very light!
@neilaaitchison4473
@neilaaitchison4473 3 жыл бұрын
Great video again .you make it look so easy .
@SeasideGarage
@SeasideGarage 3 жыл бұрын
Editing all the cursing and desperate methods out helps.... ;)
@edh7492
@edh7492 3 жыл бұрын
Excellent work, the front of the bearing often falls apart when you push the hub out, the whole process is always a fight, strangely satisfying to do however. Those struts look like they were found on an archaeological dig! 😅
@SeasideGarage
@SeasideGarage 3 жыл бұрын
Thanks! Haha yes... Our country is rough on cars.... The roads where white today, and it was not snow... it was salt... :O
@edh7492
@edh7492 3 жыл бұрын
@@SeasideGarage dude I sympathise ours are no field trip but I can imagine it’s even worse for you. They weren’t beyond restoration however I’ve had to chip my way through similar in the past. Those circlips were in there though, jeez!
@SeasideGarage
@SeasideGarage 3 жыл бұрын
@@edh7492 Haha I think it took 30minuts to get them out! They where so so stuck... The eyes for the pliers snapped off instantly... ;)
@audiokees4045
@audiokees4045 5 ай бұрын
I was on the MOT and tyhe bearing was not oke in one front wheel, but when I drive the car I do hear nothing strange, also not with taking a corner. Is then the bearing bad or is it a other sound.
@audiokees4045
@audiokees4045 5 ай бұрын
Mine axle bold in middel of wheel is quite vastened, and even a big pin do bent.
@cavanstephens9250
@cavanstephens9250 Жыл бұрын
Does it matter which way the bearing goes in?
@Mads_Villebro
@Mads_Villebro 5 ай бұрын
Jeg stod lige og skulle bruge en video om skift af hjulleje på en 106... Hvem kan hjælpe? Seaside of course! 😃🙏
@michaelsandager6022
@michaelsandager6022 2 жыл бұрын
Super god gennemgang af lejeskiftet og videoen slutter med, at du ikke monterer akselbolten, men hvilke Nm skal den spændes med? Mvh. Michael
@SeasideGarage
@SeasideGarage 2 жыл бұрын
Jeg kunne ikke lige huske NM så derfor tog jeg det ikke med.. Men stramt! ;) Tak!
@twocvbloke
@twocvbloke 3 жыл бұрын
That car seems to have an appetite for bearings... :P
@SeasideGarage
@SeasideGarage 3 жыл бұрын
Yep.... hot hatch... +300.000km and a life with many "modders" have put a big strain on everything on this old gem...
@quinta3005
@quinta3005 3 жыл бұрын
you should have told people that some of the bearings only go in one way as it might of had abs so the magnet ring goes close to the abs sensor even tho yours didn't have abs
@SeasideGarage
@SeasideGarage 3 жыл бұрын
I never heard of abs rings being in the bearing? On these cars the abs ring (if fitted) are located on the driveshaft. :)
@quinta3005
@quinta3005 3 жыл бұрын
@@SeasideGarage it might not be fitted to the cars you work on but it would be helpful to the people who just use the video as a referans i like your show keep up the good work
@SeasideGarage
@SeasideGarage 3 жыл бұрын
@@quinta3005 thanks :)
@DetroitMicroSound
@DetroitMicroSound 3 жыл бұрын
One step closer to rallying....
@SeasideGarage
@SeasideGarage 3 жыл бұрын
Next up will be the clutch cable! Its going to be a big improvement to have the clutch biting point above the carpet.... :P
@MrSibby169
@MrSibby169 Жыл бұрын
Kunne du tænke dig at skifte hjulleje på den igen? 😂😂
@SeasideGarage
@SeasideGarage Жыл бұрын
Er det gået igen ? To år var ikke længe..!
@MrSibby169
@MrSibby169 Жыл бұрын
Den snerrer ihvertfald noget fra højre forhjul når jeg kører i den 😂 men okay, den har så oss været en tur på Padborg Park, kan godt være det var det den ikk ku tåle 🤣
@SeasideGarage
@SeasideGarage Жыл бұрын
@@MrSibby169 haha ja det kunne godt tænkes... Det er hård kost ! Håber at den køre godt ellers ! Den er savnet her !
@MrSibby169
@MrSibby169 Жыл бұрын
​@@SeasideGarageden kører hammer godt, har dog måtte skifte benzinpumpen på den da den døde i sommers 😅 men ellers kører den perfekt, og elsker det faktum at det er den eneste rallye med soltag 😂
@SeasideGarage
@SeasideGarage Жыл бұрын
@@MrSibby169 det er sgu fedt at høre ! Mega fed bil!
How to change the front wheel bearing.
9:39
Mecánica Automotriz chane
Рет қаралды 625 М.
Don’t Choose The Wrong Box 😱
00:41
Topper Guild
Рет қаралды 54 МЛН
УДИВИЛ ВСЕХ СВОИМ УХОДОМ!😳 #shorts
00:49
Wheel bearing replacement on site without dismantling the hub carrier
21:04
How to remove Peugeot 106/Citroen Saxo front suspension
9:36
Mark Hill
Рет қаралды 10 М.
Changer cardan Peugeot 106( coté conducteur ) partie 1/2
17:35
Front wheel Alignment   Toe In :Out
21:04
D3Sshooter
Рет қаралды 493 М.
Peugeot 106 Rear wheel bearing replacement
6:50
Seaside Garage
Рет қаралды 3,9 М.
Sostituzione freni posteriori Peugeot 106 e Citroen Saxo
24:50
Wheel bearing replacement : Front & Rear  (several methods/tools)
22:25
Don’t Choose The Wrong Box 😱
00:41
Topper Guild
Рет қаралды 54 МЛН