SEAT IBIZA 6L 1.9 TDI - COILOVER INSTALL!!

Considering becoming a subscriber & dont forgot to give the video a like 😎

[@dakawolf3226]

Great video man doing this to my Ibiza and this will be a great help 👍🏻 keep up the good work

[@sebastianmiticky2491]

great video but i never seen ibiza rusty like this

[@CarGuyLife]

It was rusty 😎 done alot of work to it recently so no rust left ✌

[@timkudryavtsev4133]

Looks great man. I like the wheel gap, it looks neat.

[@CarGuyLife]

Yup shes slammed 💪

[@timkudryavtsev4133]

@@CarGuyLife I cannot wait to install my new Tein coilovers on Mazda2. Ordered new bolts for rear strut mounts as mine seized and corroded.

[@CarGuyLife]

@@timkudryavtsev4133 aw sweet! Be careful when removing the bolts from rear shocks at the top heard they are prone to snapping on the mazda 2s

[@timkudryavtsev4133]

@@CarGuyLife I posted in the forum some pics. It was terrible. Had to go to my local garage to get these bolts removed.

[@-R32-]

Good job 👍🏼 🔥. Cheers from Portugal ❤️

[@gazza9919]

Good Video

[@CarGuyLife]

Thanks mate ✌

[@jo0eleneldesmadre]

Greetings from Mexico

[@dancool27]

Ford Puma droplinks are normally used when lowering these

[@CarGuyLife]

I currently have adjustable drop links on the car now as this was filmed while ago. Currently have adjustable drop links

[@radzisz345]

Why didn't you remove the rust from the beam and protect the chassis? A bit stupid tuning ... tightening the better parts to the rust

[@CarGuyLife]

I made this video so long ago i cant even remember my reasons at the time so can't give you a logical answer lol

[@adenblay6040]

Is it possible to do the front struts without removing the hub off the driveshaft

[@CarGuyLife]

Unfortunately not that im aware of its possible but you run the risk of dislocating the inner CV joint

[@smidc]

Where did yoh place your trolley jack to raise the car up.

[@CarGuyLife]

Subframe if i remember correctly

[@smidc]

@@CarGuyLife I need help man lol

[@juanzip-sp]

your seat ibiza is very well cared for except underneath¡¡, in europe because of the weather if it is not antigravel the floor of the car is completely decomposed, a good thing would be to disassemble the rear axle and take it sandblasting and then give it 3 good layers of paint with lacquer so that it is almost indestructible¡¡¡ and with the steering joints the same, but before doing it, repair the floor of the vehicle from rust and then paint it with anti-gravel ----> kzbin.info/www/bejne/qZ-WeJZneNB7psk

[@CarGuyLife]

Should see underneath it now it looks super clean 💪 this was a old video and car has gone through alot of change. Check out my newer videos 😊

[@jessicaandfaithfith3679]

Good job but it not could u need it an axle

[@adambociek5028]

What car are the front seats from?

[@CarGuyLife]

Seat ibiza formula edition or something along those lines

[@sebastianmiticky2491]

damn why is every car in UK this rusted 💁🏻‍♂️🥲

[@sergiudan8159]

What wheels do u have on the car wnat tu buy em too

[@cr41gr3n9]

Look like BBS Montreal’s from a MK4 Golf. You normally pick up a set fairly cheap

[@CarGuyLife]

Yup thats the one's

[@sergiudan8159]

Thank u

[@radzisz345]

zardzewiały trup

[@CarGuyLife]

?

[@daanstroo867]

How are the fk coilovers? Im thinking about putting fk coilovers on my seat ibiza 6L

[@CarGuyLife]

They are ok tbh good value for money

[@andreibeniaminene6337]

Did you had sny gap unde the hood after tightening the top? I have 2 cm of gap and is making noise. Thx

[@CarGuyLife]

Can you tell me bit more about what you mean so i can get better understanding of what you need help with ? 🤙

[@andreibeniaminene6337]

@@CarGuyLife i just instaled a suspension kit. I mounted the bushing on the strut,put suspension in place and tight the strut on from under the hud,on top. Right there on top,where you have to tight the strut i have a gap between the body and the top of the suspension when i put the car on ground,if i lift on jack ,gap gone because the shock absorber goes down while lifting. Under the hood you have something like a "plate" with ruber which you put first when thightening the strut on the car.between that plate and the body of the car i have a gap when the car sits on the groumd

[@CarGuyLife]

Hmmm thats strange i would check its the correct top mount ? If you like feel free to contact me on my Facebook page with pictures and can help you better

[@sheldonm10]

have you been parking in the sea or something how is it so rusty underneath??

[@CarGuyLife]

It was rusty 😉 thats all been sorted now and protected. Previous owner stayed near the beach i think 🙈

[@pugz16v]

How many holes get new wings

[@CarGuyLife]

I got new wings fitted ages ago in mint condition 🤦‍♂️