Segway Ninebot Max G2 banging on start and stop from back wheel and rattling fender - FIX

If you’re not bad, Max G2 ever starts banging on start or stop in the back. You will need to remove the side covers. There’s a screw underneath the reflector in the back and screw underneath the rubber cap. Once you remove the side covers you will need to tighten the wheel screws and you should also tighten any screw you see, like for the fender or anything else. I didn’t touch the shock screws though. Put the cover back on and you should be good to go no rattling no banging.

[@Tobythecooldog]

i have the same scooter, but my problem is if i go over small bumps or cracks like the sidewalk, is rattles and makes a loud sound. any solutions?

[@harrys9659]

It's probably the back fender, between the back fender and the wheel you have a metal plate and I think this is the problem of the loud sound. You probably need to remove the wheel and mount it tighter (the metal plate) and put everything back together.

[@schniedeltoast88]

just use some locktite on the motor screws and it should be permanently fixed

[@brianmc3479]

I have the same problem to

[@nufio10]

I have the same problem!!! G30E 2max any solution?🤦‍♂️😢

[@AdamPanek]

Tighten the rear wheel nuts. Don't just think they are tight, actually do it.

[@nufio10]

thanks for the information I'll do that then in the next few days. I will give information when I do thank you 😉

[@brianmc3479]

​@AdamPanek man I going to check mine to thanks a lot

[@nufio10]

and at the end makes the noise and sometimes the electric scooter turns off 😥

[@AdamPanek]

try to tighten the wheel nuts. Don't just think they are tight, actually do it.

[@xploproduction4411]

How to fix?

[@AdilErt]

Watch the video. İn the last part