SELEC TC203 Temperature Controller Programming/Parameter Setting

[@mohanji5530]

Good job 🎉❤

[@j.s.electricalinstrumentat2146]

Thanks

[@udaypremji]

Sir ji kya aap temperature controller oil extraction machine jo ghar pe use karte hai usme kaise fit karte hai uska blog banayege please

[@aayushbafna7594]

Hello. Kya iss model mein temperature ka upper limit and lower limit set kdr sakte hai? For example, below 40°c heater should turn on and above 70°c heater should turn off

[@j.s.electricalinstrumentat2146]

please set in Level-1 SPLL SPHL ACt1 CntL FOR ANY OTHER PLEASE CALL.

[@jaypatidar1949]

Sir powder coating oven me konsa rtd sensor used kare

[@j.s.electricalinstrumentat2146]

Oven ka temperature kita

[@jaypatidar1949]

Sir 200 se 300

[@samratdey5805]

Bhai mera wala Scrubber machine me lagaya hai plz Thoda bata do na kesa were lagaye

[@samratdey5805]

Plzz bhaiya

[@ParbhanshKumar-v1i]

Ke type kaise set Karen

[@gurmeetkaur1229]

Bhai please ik bar sara process bta doo konsi wire kaha lage giii

[@j.s.electricalinstrumentat2146]

Dear, 1. If input supply AC 1-Phase,then, a. Connect Line(L) to terminal no. 1 b. Connect Neutral(N) to terminal no. 2 2. Relay Terminals use as per circuit requirements. 3. Input Sensor: A. If input sensor is Thermocouple(TC), then a. TC + connect to terminal no. 8 b. TC - connect to terminal no.9 B. If input sensor is RTD a. RTD White wire + connect to terminal no. 8 b. 2 Red wires are common to be connect at terminal no. 9 & 10. IN CASE OF RTD: The resistance between terminal no. 8 & 9 and also between 8 & 10 should be 110 to 116 ohm at room temperature. The resistance between terminal no. 9 & 10 should be 0 Mega ohm.

[@hirensenjaliya7521]

Tempresar 3sekad ka veriyesan batavo

[@samratdey5805]

Apka number mil jata to bohot accha hota bhiyy

[@j.s.electricalinstrumentat2146]

7013356370

[@prasadmalode136]

Number Milega Aapka

[@j.s.electricalinstrumentat2146]

Massage karo