[Self-made table saw jig] Cut for fence

When cutting a small board with a table saw, it is very dangerous because your finger gets close to the saw blade.
There is a push block that is pushed out when cutting a board with a jig for a table saw, and although I also use it, I was still in trouble because it was difficult to hold down small boards and I could not cut them according to the dimensions. So I made a table saw jig to cut out small parts safely and easily.
The point that I devised is that the sliding scale is fixed with a magnet, so the cutting dimensions can be easily corrected.
When the saw blade is replaced with a different thickness, the cutting position also changes, so zero correction is performed with the saw blade, but since it is only stopped by a magnet, it can be adjusted without tools.
● Related videos
[Self-made table saw cross-cut jig]
→ • テーブルソークロスカット治具の自作（集塵機能...
[Table saw edge cutting jig]
→ • 【DIY】テーブルソー治具　Table Sa...
#DIY #table saw #safety DIY

[@markhedquist9597]

Very precise results here! Good work on this jig!

[@woodvillage3788]

I wanted to do accurate work, so I made this form by trial and error. Thank you for many comments.

[@J-Chong]

Ya me suscribí a tu canal... Gracias..🇵🇪

[@J-Chong]

Gracias ....ahora mismo me haré uno.

[@andreanobili2040]

Super great 👍

[@woodvillage3788]

Thank you

[@yomo4883]

1ｍｍ幅カット。見ていて笑えました。 素晴らしいです！！ 細かく見ると、0.9～0.95ｍｍですかね。＾＾ まぁOKですよね。 2ｍｍ幅で５本切った時は、爆笑しました。ｗｗ 素敵です。＾＾

[@woodvillage3788]

有難うございます。 木工ではどこまで精度を求めるかなんですけど、最終的に出来上がった時点で細かい修正が入るので自己満足です。2.5㎜幅は何に使うんでしょうね,自分でもww でも動画を楽しんでいただけて良かったです。 これからも宜しくです。

[@user-tt4ef7fz3y]

ふ

[@user-ul8eb8dy5s]

テーブルソー利用時、手袋はＮＧでしょう！素手なら切れるだけ、繊維の手袋は引き込まれますよ。！

[@woodvillage3788]

仰る通りです。 撮影しながらだとついうっかり手袋をしたまま作業してしまうことがあるので気を付けようと思います。 お心遣い有難うございます。