Setting a Bazzaz quick shifter

[@hilledegroot]

The light on my quickshifter stays on no matter what position i set it up to. So must be broken?

[@RoyRacing185]

Mine has some issues. Sometimes it works, some times it doesn’t (tested on track and dyno). But my light never comes on wenn on the stand, contact on and pulling it. Suggestions?

[@barrygraham1000]

The light can fail and lead to it not illuminating. I suggest turn in very gently until you feel it touch the bar. Once it does then turn back 2 full turns

[@RoyRacing185]

Thanks! But think there is more wrong. Used this video (kzbin.info/www/bejne/h5jVlXWjYqqdedE) to test it and I’m never getting a closed circuit (tested all pins and all ways). Have another bike with Dynojet QS on it, that one works so now gonna test if it works on the problem bike with Bazzaz Z-FI TC...

[@barrygraham1000]

The switch is electronic. When the proximity sensor detects the bar it switches on the circuit. You can only test it electronically in operation. Dynojet shifters are simple mechanical on off sensors.

[@barrygraham1000]

You can test them with a basic circuit tester by pushing or pulling. The Bazzaz needs a 12v supply to operate. When the sensor detects the bar it electronically switches on and current will flow. It will do nothing in any state with just a multimeter.

[@RoyRacing185]

Okay. Is there a way to test the system with a multimeter? I can reach the 3 wires when everything is mounted. Btw, internet rules. Problem solving from America to the Netherlands 👍🏻