Me pueden ayudar hacer la configuración del método RTK gracias.
@amaraholuseyiadebambo7684 Жыл бұрын
My base suddenly no longer appears when searched with wifi, what could have gone wrong?
@Emlid Жыл бұрын
Hi there! Please contact us at support@emlid.com. We'll be in touch with you as soon as we can.
@WA4OSH Жыл бұрын
What frequencies are you using for your RTK correction stream? What is your SF, CR and BW? ISM bands available for LoRa vary the world over by ITU region and country.
@Emlid Жыл бұрын
Hi Konrad! The frequencies for LoRa radio are 862-1020 MHz. Reach receiver assigns an allowed range once it determines the position and the region. Could you please specify why you need details about the modulation bandwidth, spreading factor, and error correction rate and contact us at support@emlid.com for further info?
@WA4OSH Жыл бұрын
@@Emlid I was asking about the frequency used for an estimate of the free space path loss. Here in the US / ITU region 2 we can use LoRa on 902 to 928 MHz using the ISM band In other regions / countries other ISM bands are available. The other parameters determine the process gain could one expect for a realistic link budget.
@Emlid Жыл бұрын
@@WA4OSH Thanks for your interest! The best way to discuss these details would be to contact us at support@emlid.com. Our support team is always ready to help you.
@mohnishrai Жыл бұрын
i did this setting .....but at 1 km rover goes in single mode and show waiting for fix correction......... does anyone tell me range of fix ?????
@Emlid Жыл бұрын
Hi Mohnish! Most likely, there are obstacles between the base and rover. LoRa requires the line of sight between devices to reach the maximum range. If you need help, please contact us at support@emlid.com.
@ylgiceydiceyrl9360 Жыл бұрын
I have copied these settings exactly and all I am receiving is “waiting for corrections” as well as no solution
@Emlid Жыл бұрын
Hello, please reach out to us at support@emlid.com and we will help to troubleshoot the setup.
@MichelCousineau-ms6gc Жыл бұрын
is it normal that the base and rover GNSS update rate are not the same Base at 5GHZ and Rover at 1GHZ ? RS2 BASE setup GNSS update rate at 1hz kzbin.info/www/bejne/gqqYknZtmsycmbM RS2 ROVER setup GNSS update rate at 5hz kzbin.info/www/bejne/gqqYknZtmsycmbM
@Emlid Жыл бұрын
Hi Michel, Yes, this is completely fine!
@Emlid Жыл бұрын
Hi everyone! Recently, we’ve redesigned ReachView 3 settings view to simplify your work. Check out our post to learn more about changes: community.emlid.com/t/reachview-3-update-redesigned-settings-view/31658