Setting up the neck angle jig

[@BradRemillard]

You use the truss rod to align the neck. What if the the truss rod channel isn't perfectly parallel to the sides? If it is off even it is off a tiny bit over the length of the neck won't that throw the alignment of the neck off left or right depending on the channel?

[@OBrienGuitars]

The truss rod is used to dial in the correct amount of relief in the neck. I think the channel would have to be off considerably to make a difference.

[@BradRemillard]

@@OBrienGuitars Thanks Robert. I purchased this from LMI. I noticed for the nut to the 14th my truss rod channel is off maybe 1/32 to 1/16th. from left to right. Wasn't sure if that is a skoshe or BAD (technical term). From what I took away from the video I will adjust any variance during the fitting process. Thanks again for quick reply.

[@OBrienGuitars]

@@BradRemillard I think it will be fine.

[@Shinando57]

Obrigado pela resposta! Vou procurar em lojas de ferramentas, então. Abraço e sucesso Robert!

[@OBrienGuitars]

Obrigado! Sim, você consegue comprar o guide bushing em loja de ferramentas. Boa sorte!

[@Shinando57]

Olá Robert! saudações mais uma vez do Brasil! Acho muito interessante esse video e a maneira como você faz esse processo do encaixe do corpo e braço. Mas tenho uma dúvida: onde eu consigo (aqui no Brasil) comprar esse "guide bushing"? Consigo comprar em lojas que não sejam especializadas em luthieria? Grande abraço!

[@OBrienGuitars]

Call them. They have it.

[@Andluth]

Where can you get the plans and hardware kit? I did not see it on the LMI site.

[@MrYllib54]

It