Shaft Alignment Procedures - Reverse dial method - 1st video

Subscribe on RES global channel, like comment and share this video.
Reverse Dials Method
When using a reverse dial method, two measurements are taken on the rims of the couplings to determine shaft offset at two points. Shaft angularity is then calculated as the slope between the two offset measurement points. This measurement normally requires the machines to be coupled.
#maintenance #reliability #Alignment #mechanical #resglobal

[@chelseaveck]

Thank you Alaa Thabat for uploading this informative video...

[@doyvp7342]

Super class. Thank 🙏🙏🌹🌹

[@antoniomarquez6735]

I think I caught a mistake... Mh on 24:44 is supposed to be 24 (48 / 2) right?

[@michaeltolentino3914]

first procedure for reverse allignment

[@thetruth156real3]

I don’t see if the vertical is in, how both horizontal measurements are plus, surely one side must be minus?