SHARK Raw Elastics

[@TheRegsy]

Thought that was how it went but didn't want to break the side panels if it wasn't. Thanks :)

[@Vampfy]

Awesome! Thank you, I too was worried about breaking the side panels

[@elfbey06]

Nice

[@VinCent-xy5lg]

Thankyou Thankyou Thankyou Thankyou Thankyou very much

[@llbakall4980]

I've noticed that after a while the straps seem to loosen and because of this the mask doesn't fit flush and sits lower creating a gap where your brow is. Could removing the straps and letting them sit freely, without tension cause them to shrink back again and therefore be tighter when you put them back in???

[@Rockid9040]

If you unclip the straps from the goggles, you should find that the strap is sewn in 4 spots creating open-ended pockets. There's a pin through the furthest one out, and you can remove this pin and move it to one of the other pockets to adjust the tightness. Just did it on mine, feels like new! Hope this helps.

[@petervandenhoogen37]

@@Rockid9040 Thank you! Just did this. Works brilliantly.

[@finndakaas5736]

@@Rockid9040 woww thank you, comments are always better than the video 😂

[@xpndblhero5170]

Do they make replacement parts for the Raw helmets? I'm looking for new parts or replacement parts for mine...

[@Mrremusakajack]

Great . Now the flimsy ornament glued broke off and is hard to find a spare .

[@AL197845w34832479823]

stupid helmet...so useless lol