It's some smd components near the Servo IC are bad? Is probably need to see the uP comunicate, correctly with the motor driver.
@weakbit63311 ай бұрын
Does not. The µC send not signaling out to spin up the spin-motor. This is also a mystery. Did you have a service manual? maybe I see something in it I do not have one. Thank you weakbit
@LibraAudioLaboratory11 ай бұрын
@@weakbit633 Sadly i' dont have the service manual, the only thing is to look the datasheet, of the uP if is output any signal to servo / motor driver.
@weakbit63311 ай бұрын
@@LibraAudioLaboratory I've the datasheet from the BA6392FP and on pin24 VSIN and pin23+25 VPIN are clear but there is no signaling from the µC this is one issue that should be fixed but if the µC doesn't send then it could be that it is defect and this is impossible to get a programmed one. kismet or bad-fortune! But thank you for your ideas weakbit