Siemens S7-1200 PLC encoder high speed counter setup in TIA portal and TP700 HMI programming. Eng

[@mini-momentclips]

Your English speaking is so nice for non native speaker ❤❤ Very knowledgeable tutorial Keep it up

[@Aeeeeelex]

You’re the best. Keep up the good work!

[@IGSElectronics]

Thanks! Will do!

[@bendjakovic955]

Bloody brilliant!! You have a new subscriber Ingus 👍

[@JakobHarlev]

Such nice content :) Thank you so much. I just recently found your channel. I will be watching a lot of your videos from now on! One question, why are you talking about an S400 PLC on this video and the previous one? I only see you using a S1200 and S1500 on the video.

[@framos9991]

Helpful! Thank you!👌

[@thomassaook7787]

Great job, thank you

[@kme8134]

This is great, thanks boss.

[@davidbooth529]

excellent vid. Well done!

[@tpd-jy7qm]

Thanks for explanation, can you explain how to convert the results to RPM? Which encoder did you use here?

[@فهيمعليعبداللة]

Hello How are you? I am Fahim and I want to help you I have a device plc cpu 1214c that has been programmed and a protection key has been placed and I cannot open the program and I want to delete the program from the device. What are the steps to delete the program from the device? Thank you for your cooperation

[@1986ah]

What if the counting value reaches the upper limit of a double integer? How could we reset it again?

[@veys9655]

it reset it by itself. Then it start again at the begining value!

[@tpd-jy7qm]

I am using Push-Pull encoder, and i conected A, B and Z to 0.0, 0.1 and 0.2 inputs of 1215C PLC. Program is counting something, but I am not sure are reading correct or not ("countersingle phase" doesn't read anything at all). Can someone explain how this could be fixed, so it can work properly with my encoder? Thanks.

[@kondito88]

Thx