Рет қаралды 6,438
Hi Folks,
This is a quick DIY project that only requires basic construction lumber and pocket screws. The stand is made of basic 2x4 framing lumber and some scrap 3/4" plywood. I did the entire build with pocket hole joinery.
Measurements:
Width: 26-1/2"
Depth: 20"
Legs: 29-3/4"
Front Rails (top and bottom): 20"
Side Rails (top and bottom): 17"
What I use to build the stand:
- Bauer 10" sliding miter saw. (Harbor Freight - yes Harbor Freight :))
- SawStop Jobsite Pro
- Festool Router
- Festool Dust Extractor CT26
- Kreg Pocket Hole Jig
- Kreg Pocket Hole Screws (2-1/2" for 2x4's / 1-1/4" for the top)
- Kreg Right Angle Clamp
- Kreg Heavy Duty Bench Clamp System
- Amana Tool Flush Trim bit
Casters:
- Rockler Workbench Caster kit with Quick Release Plates www.rockler.com/rockler-workb...
- I happened to have these that I intended to use on my workbench but never installed them so decided to use them on this project. But as I say in the video, standard casters with a brake would be just fine and will cost a lot less.