Simulation of compression spring in SolidWorks

[@UsmanSaleemSulehri]

Great Work. Keep it up!

[@mecheinsider9533]

Thanks a lot!

[@MuhammadArslan-ne8fi]

You can use advance fixtures to restrain the top end to prevent the spring from buckling. BTW great effort.

[@mecheinsider9533]

You could do that but it would remove the real life scenario of buckling due to plain and grounded ends.

[@MuhammadArslan-ne8fi]

@@mecheinsider9533 Agreed. For this purpose, it is recommend to ground the ends for more than 270 degrees. Meaning to create the extrude cut of 3/4 of wire dia, so that the applied force doesn't tend to bend it towards the side.

[@mecheinsider9533]

That case is known as square and ground ends. Usually it is not cost effective due to the additional machining required so that's why i chose simple plain and ground ends to simulate.

[@cutelariacajarana3075]

Hello, can you tell me if springs with the same K and different diameters have different speeds? Example; a spring with a diameter of 50mm with a total length of 500mm, assuming that it would have a rate of 0.500 kgf/mm and another spring with the same K and the same length but with a diameter of 60mm would have different speeds. If you compress both and release, would the speed be the same or would one extend faster than the other? This is my question, if you can help I would appreciate it. Thanks.

[@LivYi]

Thanks for sharing the great work. I've got a message "solver failed". Any suggestion for solution?

[@m.tayyabkhan4861]

nice work.

[@mecheinsider9533]

Thanks!