SMACO S300 mini Scuba Respirator troubleshooting

[@allurac179]

Instrucciones también en Español por favor. Es muy bonito vender y después ya te apañaras. Muy disgustado con ustedes

[@tinnakonchhatrasen6337]

The most troublesome issue is the air leak from the pin hole underneath the regulator. I have changed many o-ring on the core but the leak could not be fixed - the leak can slowly breed out the air overnight and this can empty the tank from 200 bar to 0 as said. Thanks to SMACO they sent me a few core equipped with spring and O-ring. I change it and test underneath the water however the bubble from air leak is still visible.

[@SmacoSports]

Hello! Please contact our after-sales person [e-mail] and take a video of the air leakage and send it to us. We will be happy to serve you. Thank you!

[@1SeanBond]

@@SmacoSports please help him! Thanks a Smaco owner! Be safe!🙂✌

[@SmacoSports]

Sorry for bringing you a bad experience. Please contact our customer service again. We will always help you to solve it. Thank you!

[@ЕжЕжов-ъ7х]

how long does the pressure in the cylinder last? is it possible to fill the cylinder with pure oxygen? thanks.

[@SmacoSports]

Different people have different lung capacity. The use time is also different. The 0.5L gas cylinder in the video is usually used for 3 to 5 minutes. Pure oxygen cannot be filled. Only compressed air for human breathing can be filled. thank you!

[@ЕжЕжов-ъ7х]

@@SmacoSports you don't understand. a filled 200 bar air cylinder is at rest. not used. the air is infiltrated through the valve. how long will the pressure of 200 bar last?

[@andreamillessi9189]

Hola me prodrias traducir ak eapañol vuestro video... ya que tengo un mini scuba que se me rompio y no se como arreglarlo... gracias

[@SmacoSports]

Puede seleccionar el idioma deseado estableciendo las teclas en la esquina inferior derecha del vídeo。

[@joeyengebretson3110]

Mine will not release air. Through breathing or Through the relief valve. The pin under the relief valve just gets pushed lower and lower

[@robertbernat6660]

for answer and help I would be very happy

[@robertbernat6660]

Hi where do I get such wentil ?I have the same problem

[@MohamedElSayed-vd7dc]

Hi. I do effort to breath in... how can I just it ?

[@tombueno]

4:55

[@covisko]

Hello smaco, is the newer version s500 better than this one?

[@SmacoSports]

Yes, we have added constant pressure technology and master valve switch regulation, which is safer and lasts longer.

[@JanK001]

Hello. Unfortunately, the rupture disk of my Smaco s300 is defective, air is leaking out, I need a replacement, please ... where can I get the right one? Kind regards

[@SmacoSports]

Hello, thank you for your feedback, please send the small video of air leakage to what [e-mail] Email, we will help you solve the problem.thanks.

[@JanK001]

@@SmacoSports Good Morning, It is the rupture disk, it is defective and I need a replacement. where can I get the spare parts from? Thank you in advance. Kind regards

[@SmacoSports]

smacosports.aliexpress.com/store/4195008?spm=a2g0o.store_pc_groupList.pcShopHead_6601530.0

[@JanK001]

@@SmacoSports Good Morning, It is the rupture disk, it is defective and I need a replacement. where can I get the spare parts from? Thank you in advance. Kind regards

[@JanK001]

Unfortunately I can't find a rupture disc as a spare part under your link. please be a little more precise. Kind regards

[@edvaldooliveira2316]

Onde eu encontro pra comprar

[@SmacoSports]

smacosports.aliexpress.com/store/4195008?spm=a2g0o.productlist.0.0.78fd68f3RY23J4

[@rafald7774]

Hi I have the last problem with the core. Where can I buy one? I dont see it on aliexpress

[@SmacoSports]

you can contact our by [e-mail]

[@korfabi]

thanks a lot

[@SmacoSports]

You are welcome

[@Xhenrik1]

Help:(!! I followed the instruction, pump 'bar indicator ok, but the bottle indicator does not indicate pressure / there is air in the bottle, I unscrewed/

[@SmacoSports]

Hello, please contact our customer service, and send the relevant video to our customer service email [e-mail] We will provide you with high quality service. thank you!

[@knalfin]

hi may i know where i can buy adapter for normal pump ???@chaowu michael

[@SmacoSports]

smacosports.aliexpress.com/store/4195008?spm=a2g0o.productlist.0.0.4a5571dbhZBR3g

[@SmacoSports]

Yes , you can order the adapter in our store: www.aliexpress.com/item/32961798506.html?spm=a2g1y.12024536.productList_435825859.pic_1

[@anasstaidi8947]

Do you knows how to buy the core i have the last problem

[@SmacoSports]

Yes, you can visit our store smacosports.aliexpress.com/store/4195008?spm=a2g0o.productlist.0.0.59e271dbXBiRej

[@SmacoSports]

smacosports.aliexpress.com/store/4195008?spm=a2g0o.productlist.0.0.4a5571dbhZBR3g

[@diversdown2116]

there is several problems with this system. 1st. you get what you pay for 2nd. in the USA you must have a USA DOT hydro stamp they don't & should have a vip done this is done every year or when the tank is opened 3dr. the filter in that is probably all ready bad. and wont stop bad gasses from getting compressed into the tank. 4th. compressor should have some type of a safety so it does not go over 3000 psi if you forget it becomes a bomb 4500 psi will kill you. 5th. i have seen this system and they are cheap your life is worth more. 6th. for the money you have into this you can get certified in scuba and do it correctly. i assume you are not certified = do you know what to do when you run out of air ? so you dont get a air embolism. or a lung over expansion injury. and for those who say i am going to stay shallow it can happen in a swimming pool. 7th. this is made in china the same people that brought you a virus they dont care if something happens to you there is no way to hold them accountable. in the USA these are sold as a back up in case something happens to the main unit. LAST of all your life is worth taking a class and doing it properly

[@SmacoSports]

Thank you for your attention 1. Our products are sold all over the world and conform to the European Union standard (TUV) 2. Our products are equipped with qualified oil-water separator 3. Our products have safety and explosion-proof devices. When the pressure exceeds 4500psi, the protection device will be triggered to ensure the safety of users. 4. The product comes from China, but it's safe. The virus is breaking out all over the world, not just in China. There are more than two million people infected in the United States, which is a natural problem and not a human thing.

[@covisko]

#6 if it can happen in a swimming pool then getting this product or not doesn't back your point.

[@diversdown2116]

@@covisko you can get a Embolism in as little as 4 ft of water. Any one using any breathing Apparatus under water should be trained properly.

[@fluffymerman1138]

@@diversdown2116 first of all you are a racist you need to get that fixed second I use this as a bailout bottle and it works just fine third it even says in the directions you should get certified to use 4th any jackass can go online and buy a complete scuba tank and regulator so how is this any different 5th all of the bailout bottles like this spare air and several others on the market do not get a yearly viz unless you are having it filled by a dive shop and if you are taking it to a dive shop you are doing it wrong lastly it does have a hydro stamp how about you learn a little something about a product before you slam it.

[@buds8662]

i don’t have one of those on my bottom of my scuba tank

[@SmacoSports]

Can you describe your cylinder in detail? This can better help you solve the problem. Thanks.

[@stephenmurrell1920]

when breathing in makes Very loud vibrating noise; do I need to Adjust flow anyone may respond to this; otherwise seems to work ok; not tried in water yet, Thanks in advance

[@plane_spotter_italy]

stephen murrell dose it do it out side the water or in if outside its ok

[@plane_spotter_italy]

Sorry I have a3 problem 1 I can’t screw the top head were the purge valve is it’s to difficult. 2 I can’t push the green o ring al the way back were it’s should be . 3 i can’t take of the metal disc to repare the leak from the bottom in the video it seams so easy

[@SmacoSports]

Hello, please contact our customer service. And take a small video of your problems to us, thank you! Our email: [e-mail]

[@robertbernat6660]

I have Smaco 300 plus

[@SmacoSports]

Hi friend, you can get the core in our website www.smaco.com.cn thanks.

[@langitke7714]

Tidak ada sparepat nya di indonesia kasihan pelangan saya

[@SmacoSports]

Halo, ada apa denganmu?

[@langitke7714]

@@SmacoSports di mana tempat beli sperpat nya

[@langitke7714]

@@SmacoSports pengaturan on-of nya rusak

[@SmacoSports]

@@langitke7714 www.aliexpress.com/item/4001049414368.html?spm=2114.12010612.8148356.1.4bd416d6UTBlqR

[@SmacoSports]

@@langitke7714 www.aliexpress.com/item/4001049414368.html?spm=2114.12010612.8148356.1.4bd416d6UTBlqR

[@金玉男-t3r]

日本人いないなぁー

[@SmacoSports]

日本語の説明書があります

[@diversdown2116]

do notice they never answered why they are not DOT certified for use in the USA they know they would never pass because they are a Inferior product

[@geryreiter5638]

Darf ich so einen Scheißdreck im Hausmüll entsorgen?