Smallest 5000mW VTX! AKK TX5000AC | Install & Setup & Penetration | Ultra Long Range FPV

[@Terry-cv9rz]

Nice vtx!

[@joshuasampson6971]

Does anyone know when the alpha 16 16w vtx will be for sale? I saw it on the website and then I tried to buy a few days ago and it was taken down.

[@iFLYXWings6589]

Just checked with AKK rep, they don’t have an estimate date as well due to chip shortage

[@joshuasampson6971]

@ thanks for checking

[@skyrctechie]

What's the range in open area?

[@iFLYXWings6589]

I did not had the space to test it but you can review other peoples test kzbin.info/www/bejne/fHWacomFpdiUebssi=mnsumAAU2bfwjj6G

[@skyrctechie]

@iFLYXWings6589 Thanks 👍🏻

[@chicken69190]

5:30 shorten the wires 😭

[@iFLYXWings6589]

Yes, I will agree shortening will be better but since it’s for testing purpose, I did not bothered…

[@nksharpshooter]

Thank you for the information and test! Greatly appreciated mate

[@iFLYXWings6589]

Happy you enjoyed it !

[@ablewingss]

Will this work with any digital systems?

[@iFLYXWings6589]

No, at least at the moment. This is 100% analog

[@ichhabeporsche6151]

I desperately need help. I recently bought a radiomaster pocket and build a drone using a speedybee 405v3 stacked. I’m having trouble getting the radio and esc to bind. Im not even sure if those two are compatible. The receiver I bought does have elrs build it. Configured the drone on betaflight as far. Due to not capable of binding, it doesn’t show the stick movement from the radio on betaflight. I need help 😅

[@ichhabeporsche6151]

In addition I don’t even know how to configure the radio. Like the arming button or turning on the leds. It’s all very overwhelming. Would appreciate some assistance

[@iFLYXWings6589]

Ok … sadly there is not a simple answer to uncovered all of this, but, I have made a series of video to explain most of the questions you have, I will request you to review them 1 by 1 in sequence. And then if you still have questions, you can let me know FPV 101: How to get started from ground zero? kzbin.info/aero/PL8oE9qQrTLtdE1Bal_FKV3PckijUU5-ln

[@lifebehindtheselens]

I had the same issue u have to use expresslrs configurator update the elrs on both the reciver and the radi to same version , and set a bind phrase so u can then bind on startup @ichhabeporsche6151

[@BLGDrive]

You have to flash your radio and the receiver using the ExpressLRS Configurator. You can look the download up. Make sure to enter the same binding phrase while configuring both the tx and rx. In betaflight you have to select crsf as rx protocol and in the ports tab turn serial rx on for the port you soldered the rx to. There's many tutorials out there but these are basic installation steps and somewhere to start troubleshooting. I have had a flight controller which refused to communicate with my elrs rx, however a different brand (both fc and rx) did work for me. When you're just starting out it can be very confusing but it will all make sense :)