Smoke alarm using Arduino uno and smoke sensor mQ2

[@dennohpeter]

best straightforward tutorial I have ever come across, +1

[@identica450]

Thank you so much

[@jenifersahana2021]

@@identica450 code pls jii

[@mohamedsameerah1383]

I have a doubt y arduino... Without that u can do rgt... Bcoz same work smoke detector does

[@sandnyapatil3215]

where did u get the code from?

[@lelandtsnyder9684]

Example code comes with the Arduino SDK kit which is free to download. A quick google should lead you to it.

[@fadilabadaoui6553]

What is the program you instal in the laptop that runs arduino code for a smoke detector please ?

[@arduinoprojets4718]

Give them code as long as you have it will be better

[@6ix9ine_edits]

Code please I need code please.... help me

[@nithyakala2607]

Please give me the coding

[@jacksonjr2521]

Bro kya hum fire fighting robot main flame sensor ki jagah smoke detector used kar sakte hai kya???

[@shanealvares9489]

Where is the code !🙄

[@thisgoodgamingyt123]

Not working😥

[@Nii_Alpha]

no code???????

[@ikicute]

can you give me a coding?

[@shreshthgupta1134]

sir when i brought smoke near sensor value is increasing

[@iamprathameshkadam]

Code plz

[@montoyajonab.7434]

code please

[@NiharikaVyamajala]

code bro

[@surajthapa2139]

Doesnt work

[@marinerankitkushwaha4178]

nice dude

[@jhetropascua8343]

Codes pls?

[@hasmukhvaza312]

ENJOYE /* AnalogReadSerial Reads an analog input on pin 0, prints the result to the Serial Monitor. Graphical representation is available using Serial Plotter (Tools > Serial Plotter menu). Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground. This example code is in the public domain. www.arduino.cc/en/Tutorial/AnalogReadSerial */ // the setup routine runs once when you press reset: void setup() { // initialize serial communication at 9600 bits per second: Serial.begin(9600); pinMode(13, OUTPUT); } // the loop routine runs over and over again forever: void loop() { // read the input on analog pin 0: int sensorValue = analogRead(A0); // print out the value you read: Serial.println(sensorValue); delay(500); // delay in between reads for stability if ( int sensorValue=0){ digitalWrite(13, HIGH); } else digitalWrite(13, LOW); }

[@sanjayniranjanbalaji9530]

;lol

[@muhamadheral9180]

@@sanjayniranjanbalaji9530 why lol ?

[@blackbox6841]

code please

[@srikanthmanoj2003]

Code bro

[@identica450]

upload analog read code which is in example of arduino