SOLID EDGE ST8 - FRAME DESIGN

[@AbdulRauf-le1el]

The best frame designing in solid edge. well done.

[@OktoPutsch]

Very interesting, now i understand better the frame designer and the features on assembly. Thank you very much :)

[@drafter3ddan2d2]

Very good

[@iskandarneosia9852]

my Frame Components Utility was gone, what should i do ?

[@JK-cm7gg]

Hey, Thank you for the great video! How do you define the material of the frame? I tried to build one by your example, but in the assembly the frame is still in that default material pattern, while all the other parts are steel or whatever. I would be thankful for an advice on defining the material of single parts in the assembly.

[@katharmukesh]

can you make video for part detailing drawing with all features..

[@krzysztofgad3662]

kzbin.info/www/bejne/kJDIq6eEicembqs you mean this.

[@sandrakoltes]

Very good, thanks for the instruccion, but I do not undertud why you used the ordered emviroment and not the sincro, thanks again!

[@krzysztofgad3662]

I do not work too much in solid edge, all the time, I learn this program and easier for me to work in ordered.

[@manojkrishna9969]

Hey I have to calculate the forces on beam when it is with a movable weight on the axis, is it possible to have some demonstration?

[@Rapbando]

Nice but plates could be created as sheet metal document and you could go one step further including weldments as a fine touch :)

[@johannes8688]

Can anyone tell me where the green table in the bottom right of the board comes from?

[@krzysztofgad3662]

Yes, it is an information table with coordinates of starting points and line length, inserted during the editing of the video.

[@johannes8688]

thank you, but i have another Question for you. what do you do while you pull the line, you can pull the line to the right Point? Which button du you press or how do you did it in your Video?