SolidCAM chamfers

[@freedomenergy6644]

Thankyou so much. You are very good teacher and very good at explaining.

[@Rako_Studios]

You are welcome, thanks for the comment!

[@LucasIsBusy]

Could you do a video on back chamfering with a double sided chamfer tool? Not much out there. :)

[@Rako_Studios]

Good suggestion but I went to HSMWorks and am still learning that. I will keep it in mind though, I agree there is not much out there to explain how to do double-chamfers. That is one reason to pay for a package. If you bought SolidCAM, they should be able to walk you through the procedure.

[@Hanal503]

simple 2d profile..........bottom...simple! or angle....3d contour...chamfer!

[@canszzz]

Sir when I try this with the 3d profile, there is a different chamfer on the angled surfaces.

[@Rako_Studios]

Yes, the width of the chamfers will change due to the geometry. That is why I do the angles separately with a smaller chamfer-- check out the whole video to see how I compensate for this.

[@Hanal503]

use :)))))) 3d chamfer.....from 3d contour strategy.

[@umitmakina9024]

Thanks

[@Rako_Studios]

You're welcome, I hopes it helps you with SolidCAM.