Solidworks Simulation : Bonded & Contact Local Interaction Assembly | FEA | DP DESIGN

Contact us on the given links for Projects
Follow us on our Social Media Platforms Listed below.
LinkedIn (DP DESIGN) : / dpdesign18
Instagram (DP DESIGN) : / dpdesign.solutions
LinkedIn (Bhavik Joshi) : / bhavik-joshi-a74a8a125
Instagram (Formula SAE) : / formula_sae_international
Instagram (BAJA SAE) : / baja_sae_international
#solidworks #solidworkstutorial #simulation #flowsimulation #cfd #fluiddynamics #like #subscribe #trending #becauseracecar

[@ridvanrizvanoglu5800]

Is "bonded" right choose here? I mean just bonded is mean fixed, no rotating I think. But in situation with crank shaft it must rotatable, isnt it? So isnt "connect" tepe is the right choise?

[@dpdesign3477]

In the video, I used "bonded" as a quick example to simplify the demonstration. "Bonded" means the parts are fixed together without any relative movement, which is not suitable for a rotating component like a crankshaft. For accurate simulations involving rotational motion, such as with a crankshaft, you should use a "revolute" or "pin" connection type. These connections allow for the necessary rotational movement between parts. The quick example was just to illustrate the basic setup.

[@ridvanrizvanoglu5800]

@@dpdesign3477 understood. Thanks

[@NarutoUzumaki-si9bc]

Well explained

[@dpdesign3477]

Thanks