Solidworks tutorial | How to make Syringe in Solidworks | Solidworks

[@danhuayan9863]

I followed the whole tutorial and it was awesome! Thank you!!!

[@CADCAMTUTORIALBYMAHTABALAM]

Thanks., i wish you enjoyed.

[@srikarthikcb4177]

Why you didn't given draft to syringe barrel part? for injection molded part we need to provide draft right?

[@jimenaurbina3229]

Thank you so much! It work for my homework

[@NELUMINDRALAL]

I modeled syringe according to your instructions, Thank you so much..

[@CADCAMTUTORIALBYMAHTABALAM]

Thanks for watching, i hope you enjoyed.

[@charlestoneoyoo]

Great tutorial , really learnt a lot, thank you

[@CADTUTORIALmax]

video is good!

[@sebasro9233]

hello, what graphics card did you use in the video?

[@xBlackThoughts]

You should have used the straight slot with center point on the gripping surfaces and pressure surface and it would have been a lot easier. 🙂 But again......nice Video. 👍👍

[@alonsorodriguez5613]

Nice Tutorial, as always, I've learned a lot.

[@CADCAMTUTORIALBYMAHTABALAM]

thanks i hope you enjoyed.

[@ugonnafredrick5887]

Can you show a flow simulation from this syringe through the needle please?

[@abdalkaderalnazer]

always creative!! we need some about complex surfaces

[@CADCAMTUTORIALBYMAHTABALAM]

ok i will try to make some videos on surface tools.

[@amirulizzat636]

it is ok if we seperate needle and that green things?

[@francescopadovani67]

Great tutorial thanks! But please learn how to use straight slot!! There is one single button to draw a slot instead of lines, circles, mirror and trim!! Anyway thanks for the tutorial!

[@azikiv1631]

Thank you. Great video.

[@drtechro]

Thanks ! Great tutorial.

[@RajanKumar-kn9ll]

How to design mold for syringe please suggest any video

[@kilomikesierra7840]

Thanks for uploading this :)

[@DIVYABME]

Nice!!

[@hooipengcheah8766]

Can you do the Leur Lok Syringe, that the syringe with a screw thread.

[@kasunmadusanka7675]

Can you provide a reference book with the dimensions of the machines?

[@reremohamed1818]

can you please make a video about how to model the cap of the syringe. I tried to do it, but it didn't work with me. thank you for your video, it helped me a lot.

[@johnpower2159]

hi buddy when r u making part 3 in chain and sprocket for motion? thanks :)

[@knowledgecentre2907]

Sir, you please make a video on BRUSH FOR POLISING SHOES. THANKS.

[@gautamhelange2769]

Thank You..!

[@kimloctranthi7989]

Theovergame and tran kim loc

[@yurysiruts8950]

gj