SOLIDWORKS WELDMENT Tutorial #7 // WELDMENT PROFILES // CORNER TREATMENT // PROFILE LOCATION

[@We-Do-NOT-Consent-303]

Very hard to understand what you are saying.

[@skeltondesignsolutionsltd]

Is it the music? I also increased the speed of the video so the same content would take less time. Maybe leave the content alone and have no music would make it clearer?

[@We-Do-NOT-Consent-303]

@@skeltondesignsolutionsltd I think it's your accent, but usually I don't have a problem understanding different accents. So maybe a better mic. will help. Yes, the music is not necessary at all. Also your screen resolution is higher then the upload resolution HD. We can not read what you are clicking on. Most laptops just have HD 1080 resolution, so your should record in HD and upload in HD, then we can see better what you are doing. No need to speed up the video, we can do that on KZbin if we need it. Thanks for asking! Cheers! :0)=

[@skeltondesignsolutionsltd]

Hi Even, Thank you for the criticism as this give me a list of items to work on. The videos are a few months old so I have upgraded some items like a better mic. The screen res is a big one all right, I have since changed back to a smaller screen just for recording, allows to see easier. Do you think a clicker ( the circle around the curser) is necessary in your opinion?. That is a good point about not speeding up the video - I will take that on board. Also I think the music is not necessary anymore but when starting off on KZbin it is hard to be comfortable with your own voice at the beginning. The accent is just part of me. Thank you again Even for the feedback it is much apricated. I will post some new videos up after Christmas with these changes. Cheers

[@We-Do-NOT-Consent-303]

@@skeltondesignsolutionsltd Yes, the yellow circle is helpful to fallow your mouse movements. I have seen that elsewhere. Also you could make the mouse pointer bigger. Good luck my friend! I also love SolidWorks I have been using it since the beginning, like 20 years.