probably because you changed the capacitors around so rather than having two good ones on one side and two bad ones on the other channel you now have one good one and one half bad one on each channel. you should have checked the esr of the capacitors.
@gerandry90294 жыл бұрын
Наблюдаю за твоими руками
@isleofmann10883 жыл бұрын
What did you do actually? Does the problem go away after cleaning? I cleaned my wallet and all my problems came🤣🤣🤣
@mhlengikwanele67543 жыл бұрын
😂😂😂😂😂😂You can say that again
@jlev505 Жыл бұрын
Diesel cleans circuit boards great. Who told you the secret? 😂
@Makhubz10224 жыл бұрын
I have that same problem with my amplifier, somebody told the cause of that protection mode could be dust. What he you are doing to fix it is a bit too much for me. How about if I opened it and air blow the whole thing? Will that help?
@a.g.gg.g.a92394 жыл бұрын
Good.
@shermelsamuel21443 жыл бұрын
Have a spyn da 320p amplifier an as I put it on the light be blinking and running with no input what causes this
@Asian_Connection3 жыл бұрын
You look like a master. Can you just point me in the right direction? I have a Mark Levinson no.27 amp. When I turn it on I heard a strong pop on the right speaker and then the unit went into protection mode. Even time I turn it on after that the power switch would pop back to off with only the pwr cable plugged in. The power light still lights, fuse is good.
@Tusharkumar-nk6ih4 жыл бұрын
super
@romeoperez733 жыл бұрын
What are them black pieces you took off thanks
@shivamchaudhary74114 жыл бұрын
Nice video
@jlmonteblack4 жыл бұрын
Porqué tiene dos transformadores? Uno es para la salida a parlante?
@ron4u2m4 жыл бұрын
All your videos are great.what kind liquit do u use??
@user-vs1wm6gs7c3 жыл бұрын
hi i dont understand what is problem ?? dust ? no more ????
@zoekulimbitlandu77734 жыл бұрын
thanks for share..
@jimilove77732 жыл бұрын
Thanks
@shivamchaudhary74114 жыл бұрын
Can you tell where the problem is and all the transistors are correct?
@boanergesrodriguezm4 жыл бұрын
Y que Reparo? Que Componente Electrónico Estaba Malo?
@La-xb6os4 жыл бұрын
estava enpolavado , el polvo causa resistencia enter el circuito
@jerrytantaydacusin2 жыл бұрын
Hi bro your like a master👍😊i have ecler pam1400 and chanel 2 was protection do you have any idea what is the problem thanks in advance boss👍🙏😊