SpeedyBee Master 5 HD | DJI O3 Air Unit | FPV Freestyle

Today i'm tested my new freestyle drone, assembled on SpeedyBee Master 5 HD frame with DJI O3 Air Unit
Full setup:
Frame: SpeedyBee Master 5 HD
FC: Hakrc F7 (target: Matek F722 SE)
ESC: Hakrc BLHeli_32 60A
VTX: DJI O3 Air Unit
Radio: TBS Crossfire Nano
Motors: iFlight Xing E-Pro 2306 1700KV
Props: HQProp R35
Fly with 6s 1200mAh battery
All footage from O3, source video - 4K 30fps + GyroFlow stabilisation on post.
Enjoy!

[@eparustefan]

Nice, what is the weight of the frame ?

[@GearUpFpv]

Full setup w/o batt - ~450g, with 1300mAh 6s LiPo - ~670g

[@WindjumbieFPV]

Nice rig and flight bro ✌🏼 Liked and subbed 👍🏼

[@GearUpFpv]

Thanks! You also have nice flight videos, subbed you)

[@NOT_ANOTHER_FPV]

I'm running the older frame....love it!

[@Markitobandito]

i have nearly the same setup and extreme whobbles in my recorded video. Dont you have the issues ?

[@GearUpFpv]

Hello. No, I don't have such problems. Check your filters and PID settings in Betaflight. As a base, I used the UAV Tech - 5'' without GoPro preset with "HIGH build quality" settings + enabled RPM filter, 48k ESC PWM (check ESC settings in the configurator) + dynamic idle. In addition, I use 3 harmonics for gyro RPM filter and 1 notch filter for dynamic notch filter. In any case, if the drone build is of good quality, stable camera image can be achieved through PID and filter settings.

[@Markitobandito]

@@GearUpFpv i will try it. Thnx!

[@Markitobandito]

@@GearUpFpv 24khz ESC PWM was the problem. I set it to 48khz minimum and it looks great. I think it is because the O3 gyro works at 24khz. thank you and good flight!

[@GearUpFpv]

@@Markitobandito great! Good flight to you 👍

[@kristersmartins8300]

@@GearUpFpv hey! I'm using a zeez f760a stack and xing2 2207 motors, do you think I could use the same preset? Thanks!