Need labelling of each & every parts . Also require function of each parts if possible
@kentvandervelden7 жыл бұрын
Nice animation
@venkatasagivarma69906 жыл бұрын
Video are excellent
@leopoldbutters80884 жыл бұрын
I studied in University. I had a drawing of some spindle of machine which actually exists, my task was to explain how to assemble/disassemble this spindle. So I made this video using the drawing. It was 6 years ago. Now I don't remember anything about this video :) I think it was very strong drilling or lathe machine.
@zaidhamamah53913 жыл бұрын
Thank you for the video, which software did you use to make it?
@ramuraju33896 жыл бұрын
nice
@mustafasanandaj33753 жыл бұрын
1:24 👍👍👌👌👌
@venkatasagivarma69906 жыл бұрын
One can easily understand
@tonyhodos27617 жыл бұрын
SolidWorks?
@Micscience5 жыл бұрын
I'm in the process of building my own milling machine and I have to come up with a design for my spindle and after watching this video it just occurred to me why don't I add extra bearings to increase rigidity? Anyways I hope this helps because rigidity is my primary concern.
@neiljborja5 жыл бұрын
Be careful with overconstraint. Incorrect bearing configuration will probably make things worse.
@hardcase16595 жыл бұрын
Just use tapered roller bearings and you're good to go. Shouldn't be any more expensive than using 3 or 4 ball bearings (assuming you wanted to use those)
@MrCoraio5 жыл бұрын
If want to know some tricks about the setting of the bearing of spindle I can explain
@Amit-sp4qm5 жыл бұрын
@@MrCoraio I plan to make a low load very high rpm spindle. I am new to this, few point I need help is: What should be dimension of the bore for bearing ( let's say 7001 angular contact bearing ) How to find correct preload and how to apply it? I guess matched pair are already preloaded!!? Thanks for your response.
@MrCoraio5 жыл бұрын
@@Amit-sp4qm so, about the bore I think must to be near 0mm,7001 it's very small. About the preload you must tu find some couple already preloaded. If you need to have more distance from single bearing you can make 2 distancial :internal, esternal (have the same thickness).
@youssefaboulenein51514 жыл бұрын
Hello please I’m a student and I would like some help for my project I need to see more details of the part . Can you help sending me the parts or something !
@Spark-Hole5 жыл бұрын
What is the spindle for, Why has it three bearings in the front, look too much for me.
@leopoldbutters80885 жыл бұрын
It's really difficult to remember. As far as I remember it was a drawing of some turning machine. I guess they needed additional rigidity at the end of the spindle.
@bortech Жыл бұрын
It's triplex-tandem, one of the standard schemes for lathe spindles, 2 angular contact bearing receives axial forces inside spindle (when drilling for example) and one ac-bearing outside.
@liquerinfrnt2 жыл бұрын
5 bearings is wildly overconstrained. If you need to handle more load, get bigger bearings. This spindle would destroy itself in a hurry.
@leopoldbutters80882 жыл бұрын
You can put "Spindle bearings schemes" in the google pictures and be extremely suprised.