SpindleBearingsPart1

This is part 1 of the spindle rebuild on my Hurco BMC20.

[@matthewvanlew5891]

Is it possible to press the spindle out and leave the bearings in place? I need to send my spindle out for regrind and they want just the spindle not the housing.

[@swapnilshinde8466]

Very nice video. Awesome work. One question for you. Hope you don't mind to answer. Why don't you heat bearing during putting it to a shaft? waiting for your answer.

[@tranginh3912]

Vòng bi này có một bộ phận nhỏ bằng gỗ

[@evangelinacorpus2662]

Cuanta deve ser la cantidad de grasa que sea la adecuada para el rodamiento.

[@derwissenskiosk8041]

This bearing is defently not to small for such a big mill... :D

[@jfcheres2120]

Seguir esta practica no es aconsejable.

[@salihciftci4859]

thats tooooo much kluber it need max 3cm3

[@Sketch1994]

Last time I filled a spindle bearing (NN3014 tapered bored bearing) I calculated the grease pack to 5.5mL. It depends on bearing air volume and the maximum speed of the application (lower rpm more grease)