Square plane problem in Normal type

[@udgeethkulkarni9083]

Sir super explanation but please improve cammera view sir .

[@engineeringvisualization1005]

Thank you share to your friends

[@MustafaMayroze]

Sir pls keep ur camera above the graph only

[@Student-t3z]

How can we contact with you sir

[@engineeringvisualization1005]

Through whatsup. 7760176578

[@thukiya4346]

Sir, We don't have any incl... A square lamina 40 mm*40 mm perpendicular to HP and parallel to VP. Dram its projection of plane surfaces.

[@engineeringvisualization1005]

Can you elaborate question

[@engineeringvisualization1005]

For 2nd position any data given

[@thukiya4346]

@@engineeringvisualization1005 Sir, what to do our clg provided only this 😑 😂 or what about another question A hexagon lamina sides 25mm perpendicular to VP and parallel to HP. Draw projection of a plane surfaces and left view.

[@engineeringvisualization1005]

@@thukiya4346 draw square or hexagon with respect to edge then rotate lamina by 90degree. It will become parallel to HP and perpendicular to VP.. draw 45degree angle line in HP plane at the intersection of Xy and X1Y1 line then draw side...you try or I will try

[@thukiya4346]

@@engineeringvisualization1005 Ok sir, thanks I will try and if u can u too so i can refer it

[@somethingspecial8163]

Sir for us they didn't give inclination to v.p so till where we draw

[@engineeringvisualization1005]

They will give inclinations in question

[@engineeringvisualization1005]

If they dont give inclinations instead of it they give information on the position

[@somethingspecial8163]

A square lamina ABCD of 30mm sides rest on corner c such that diagonal ac appear at 30degree to vp in the top view question is enough sir how to draw

[@engineeringvisualization1005]

Yes inclinations given with diagonal.. That means first position starts from corner

[@somethingspecial8163]

@@engineeringvisualization1005 they give only one inclination

[@marcos-1210]

Last fig u cut arcs on the wrong side it was on the opp side I guess

[@engineeringvisualization1005]

Ayush kamat.. It is correct I have done .