Staircase

[@leonlowenstadter9223]

One of the most detailled instructions I have seen so far on building stairs! Thanks for uploading! Perhaps you can add a video on how all parts are finally assembled - if you would have that... Thanks a lot for this video!

[@CMCraftsman]

A trammel works great for marking your inside points to make sure you’re marking every point the same for both stringers.

[@zbigniewczaykowski514]

There is a specific slightly dovetailed stair housing router cutter that should be used with that jig , not a straight cutter.

[@scottwright388]

7°

[@hoseinm9242]

everything explained very clearly , very useful video . thank you so much

[@carpentryjoinerywiganleigh9846]

Glad it was helpful!

[@georgeglz]

What angle did you use for the template when marking out the stringer?

[@carpentryjoinerywiganleigh9846]

UK building regs part K states stairs to be 42 degrees. The overall rise and overall going is divided by how many treads and risers wanted (within building regs max/ min amount) and pitch template made.

[@georgeglz]

@@carpentryjoinerywiganleigh9846 Cheers, I'm making a set of 3 stairs for my school project.

[@thedentons50]

Great video I’m a site joiner but need to make one … do I use a frame square and mark my 220 tread by my 186mm rise to get the marking the margin template

[@davidbarry7052]

This method is great.

[@Sirjohnwilliamuk]

After watching thid video will definetelly use the 4 inch screw method instead. kkk Craftermanship excellent, time to build 5 months kkk

[@Toyotaamazon80series]

🙄🥱

[@hermenegildorodriguez6876]

el espiche debería sobrepasar toda la espiga y morder o atravesar el pie¡¡

[@hermenegildorodriguez6876]

bastante chapucero

[@calholli]

No