Starter replacement guide for 2013 Dodge Avenger 3.6

[@danschool7969]

AWESOME KID!!! Easily the best video on this. You explained and showed that beautifully!!

[@JBen3774]

Very helpful video . thanks buddy . doing my daughter's starter today on her 2013 avenger .

[@Brad-dl1sz]

Take air filter all the way off and everything connected after you disconnect the battery and release it from the transmission and then or before disconnect from wire, this hurt to watch.

[@mjteevee1985]

You're welcome

[@JBen3774]

The job was a success. The car was totaled a few months later . Lol

[@mjteevee1985]

@@JBen3774 well that sucks

[@austinlee9943]

Excellent video intelligently done and explained

[@mjteevee1985]

Thank you

[@terancewilliams4794]

Very informative and very simply stated

[@chrispascoe9401]

Thank you

[@mjteevee1985]

You're welcome

[@kamalabbady6778]

I actually tried to do this job on 2013 dodge caravan but the problem is I couldn't get to the 13 mm bolt and the catalytic converter was preventing the starter from.coming out, I thought I have to remove the whole catalytic. Converter, but now you show the the wrench trick I think I am go and get it done.thanks for the video.

[@mjteevee1985]

You're welcome

[@Sheeler-Bey]

Good video bro. Thanks.

[@Brad-dl1sz]

Why every one going though bottom, just take off all of the air intake and you can replace from there

[@413rickytv]

You just gave me an idea cuz I had the whole air intake off n there's so much room. So I'ma try it

[@davidguajardo2964]

I've seen that on other videos trying to make sure it works on a 3.6 2011

[@mjteevee1985]

I personally had to do other work under the car so I didn't think about the other way

[@MacAutoDiag]

Now how do we replace you?

[@willywonka00]

Is this the same for 2012 sxt plus 3.6

[@blaqmolasses1]

Sir. Thank you, thank you, thank you!! 😊

[@mjteevee1985]

You're welcome

[@finisher3x]

I've done this job about a year and a half ago, but now I'm doing it again. Entire process was easy the 2nd go around, until I got to the part to take the starter out. On my 2014 Avenger, the heat shield for the catalytic converter is preventing me from getting it out. The last time I did this job, I was able to get the 2-piece heat shield off. This time, I forgot how I got the last shield out of the way. It's detatched from the CC, but I can't get it out.. The wrench trick does work for the starter wire ( I used a 12 mm wrench ). It's just that damn heat shield. If I can get that off, the starter will come right out of the bottom of the vehicle pretty easy.

[@stevehall1207]

Thank you Sr. For Sharing

[@mjteevee1985]

You're welcome

[@DjCBlaq]

Dropping gems.