Part 1 of the C4 to T5 conversion. Doin some cleanup on the interior and underside of the car as well.
Пікірлер: 19
@woffordfamily46874 жыл бұрын
So I did the COVID T5 swap to my 65 Vert also through Modern Driveline(neighbor works for them) and I did the same thing! I FORGOT to drain the stupid C4 before pulling it, and guess what? A big mess also!! All said and done, I am very pleased with the swap and changed the rear gearing as well. It's super fun to drive!
@Amustangguy892 жыл бұрын
Your car looks identical to my 65. Except mines a 6 cylinder about to get a 347/T5 transplant.
@dan8272 жыл бұрын
I also have a 65. Mines got a 302 in it already, had a 4 speed, just finishing up a T5 swap this weekend on it
@vrm86gt Жыл бұрын
at least you got a tarp down on the floor, good move!
@alexanderthornton1473 жыл бұрын
Hard core dude, holy shit
@charlesmacgugan29363 жыл бұрын
Did I make a good buy on this C4 transmission? Guess we'll find out when I finally test it in my falcon.
@nares073 жыл бұрын
It worked fine in mine and shifted normally. The torque converter alone was almost $300 plus the shift kit and updated valve body. It did start to get a slight leak when it got hot and someone said it was the front seal going bad, so I would put new seals in it at least. Your best bet would to be have it gone through because I don’t think it’s been rebuilt in 40 years.
@brentgreen53113 жыл бұрын
2000 explorer v6 or v8 ? Did the driveshaft work?
@nares073 жыл бұрын
I believe only v6 and any of the 2 wheel drive explorers. 90% had steel driveshafts and the rest had aluminum and they’re all the right length for 65-66 Mustangs. I never got around to changing the yoke over to the right one though so it’s still sitting in my shop unused.
@Ricksastar3 жыл бұрын
Driveshaft from explorer fit? I have a 67 coupe. Need to prob get one too.
@nares073 жыл бұрын
I never got around to changing the yoke to the proper one so I never used it, yet. It’s the same length as a stock 65-66 driveshaft but I’m not sure on the length of a 67.
@Brendanmwork4 жыл бұрын
How did you change the pedals from automatic to manual I’ve been trying to find out how people are swapping that out
@nares074 жыл бұрын
Brendan Milton I used my existing pedal setup and added the clutch pedal. I also trimmed the brake pedal to the correct size. www.moderndriveline.com/shop/pedals-and-clutch-linkage/clutch-pedals/ford-clutch-pedals/oe-ford-pedals/64-5-66-mustang-clutch-pedal/
@martinmetz89854 жыл бұрын
Where did you get ur gagues
@nares074 жыл бұрын
Marf65 they are speedhut brand
@Ricksastar3 жыл бұрын
What brand/type paint underneath?
@nares073 жыл бұрын
Rustoleum primer and gloss black..simple and lasts a long time
@TheRochoa214 жыл бұрын
What dash cluster is that
@nares074 жыл бұрын
TheRochoa21 Speedhut gauges and a Scott Drake bezel