STEERING MECHANISM SAE BAJA RACK AND PINION automobile from scratch for beginners IN SOLIDWORKS

[@Cadknowledge]

Solidworks course for animation and motion analysis for beginners: www.udemy.com/share/104jLG/

[@PavanKumar-yl3gg]

If I use rack and pinion method,,does the inner wheel angle will be more than outer wheel ? while turning ...

[@Cadknowledge]

Depends how you design it

[@aaronmcdonald4749]

Where did you get the part files from?

[@Cadknowledge]

I made my own just watching some video

[@prathameshsonawane9948]

@@Cadknowledge can you please suggest those videos or name of them please

[@mokshnagda1278]

Getting so much mate error due to which motion analysis is not working

[@Cadknowledge]

there will some issue on your mate but can't tell without looking at it

[@samarthparmar8678]

Paste error is coming. The item on clipboard cannot be pasted here

[@Cadknowledge]

Make sure u do everything on sketch mode

[@samarthparmar8678]

@@Cadknowledge at 7:23 while selecting rack do u pressed ctrl? And how did you copied it?

[@Cadknowledge]

I pressed ctrl + c in sketch mode

[@samarthparmar8678]

@@Cadknowledge I had done same steps and it showed this item on clipboard cannot be copied

[@Cadknowledge]

Can't say until i personally see what mistake you are doing

[@paragjoshi7226]

Can you provide part files please

[@Cadknowledge]

Like ,Subscribe and share to motivate link : grabcad.com/library/steering-mechanism-in-solidworks-1

[@saikrishna8060]

Assembly is not opening in grabcad.Can u pls check once .

[@Cadknowledge]

Make sure u have solidworks 2016 above version

[@saikrishna8060]

I am having 2018 version . It is showing us unable to open .

[@saikrishna8060]

Except assembly all the other parts are opening .

[@Cadknowledge]

@@saikrishna8060 ok why don't u assemble them. I am outside so it will take some time

[@nafisraihanbarbhuyan120]

No doubt it was good, but atleast speak the commands you are carrying, makes it very hard to understand. This eventually makes everything useless

[@Cadknowledge]

sorry my bad i will make new video on this with proper details ok