Radar Plotting - Basics (Calculating CPA, TCPA, Course, Speed and Aspect)

[@mfaisal2873]

Thank you very much Sir,your lecture is always the most helpful Sir.

[@sujittamang1802]

ONE OF THE BEST EXPLAINATION... EVERY DETAIL.... KEEP IT UP SIR

[@김규민-u2z3g]

thanks 🥰

[@falaksh]

Good explanation simple and easy

[@josephadereni8202]

Suggestion, write The question in the video description.

[@altamashkhan676]

YOUR VIDEO HELP ALOT SIR ! THANK YOU SOO MUCH

[@turcenoarthurjamil4364]

WA speed is 6 knots?

[@samn1807]

GREAT VIDEO SIR. SO HELPFUL

[@hanifmuhammad6457]

Sir can u explain Any Rendezvous ASAP question

[@hanifmuhammad6457]

Very nice sir Jee 👍

[@turcenoarthurjamil4364]

sir I have 3 observation...and then I can't make a straight line because they are a little bit offset to each other...for me to make the straight line should I only refer to the first and last observation to make the RML???

[@raypetersen8273]

If incoming vessel speed is 6 knots then your vessel speed is 4 knots in order to travel 1nm per 6 minutes cannot be 12 knots?

[@captankadhir2567]

where is the question sir where you writing i did not know correct that mistake after very useful to us otherwise this video is good one

[@arunhari8967]

Board is not fully visibled .

[@beterefe]

I was in tune up until you plotted own course and speed. . Everything before that was a breathe

[@anjusahu123]

Sir can you clarify me whether the speed is SOG OR STW

[@workjdupreez]

Speed through the water

[@deymhahaha9408]

Hi sir can you please tell me what is the step by step on how to operate ARPA please reply asap

[@ezrakipkoech1425]

Great video...I have a querry lets say if the CPA is 0.5 nm and you proceed with the course and speed relative with the other vessel....Will you pass ahead of the other vessel by 0.5nm or will the other vessel pass ahead of you by 0.5nm?

[@BoxerSonnyboyWatts]

Is the CPA ahead of you or astern of you?

[@ezrakipkoech1425]

@@BoxerSonnyboyWatts It is ahead of you 😊

[@AbhishekSingh-ce7mo]

Sir please make a video on UTM projection from Charts chapter of Navigation.. i am unable to understand it

[@ManojKumar-ny7xz]

sir volume itti bi km mt rkho ki pc me guss k sunna pde. pls say it loud

[@SteeringMariners]

hahaha...ok...noted:)

[@bhushanranalkar5743]

Sir ,can't see upper right corner.

[@AnubhavSingh259]

please speak a little louder next time Thanks for the video

[@ToriBerry-u6p]

Williamson Hollow

[@kuldeepsingh-fh5bi]

Vdio to puri dikhooao

[@factovl]

headphone is mandatory........

[@graham6229]

very poor sound on this one Sir