Step 5: (Adams Graphene) Ceramic Application (DIY Ceramic Coating)

[@PlzCalmDown]

Does using the suede towel to level, does applying pressure just remove product? I know instructions says minimal pressure but it’s so tacky without pressure

[@TomsDIYGarage]

If it's overly tacky you may need to level it out sooner. My environment was 60-70 degrees fahrenheit and less than 50% humidity. From my understanding, pressing too hard with the suede leveling towel would be like prematurely doing the final buff. The goal is to allow the coating time to flash properly, then level it out with the suede towel to minimize high spots and finally use a clean microfiber to buff off any remaining high spots. With the suede towel you are moving the product around just enough to avoid high spots, not trying to remove product.