Step-by-Step: STM32 Development Environment with OpenOCD and Visual Studio Code (Linux)

[@cantaff0rd2]

very nice worked from the first time like a charm amazing env vs code is my fav editor by far

[@sabilibili2271]

Finally!!!!! i get this work from here 😭 Thanks sir!

[@ekasusilo]

Happy to help

[@user-vm3im7td2m]

Thank you dear .

[@enlinea777]

verry good work👍👍👍👍

[@Toha_Bog]

when I am running this command I get this error: (Command) ./configure --prefix=/usr/local --enable-ftdi --enable-stlink --enable-jlink (Error) configure: error: libjaylink-0.2 is required for the SEGGER J-Link Programmer How can I install libjaylink-0.2?

[@ekasusilo]

sudo apt-get install libjaylink

[@amaarebrahim1849]

I couldn't install libjaylink-0.2 with "sudo apt-get install libjaylink". I had to run "sudo apt-get install libjaylink0 libjaylink-dev"

[@shreyasdeshpande9858]

Hello Sir , I have followed everything and I in final step debugger also runs successfully, but I cant observe output on my board. I am using STM32F103 custom made board.I have choose the blink example accordingly. I have also changed Port and Pin numbers accordingly, but after debugging I cant observe blinking of the LED. but debugging starts successfully, I can step in each instruction.

[@ekasusilo]

What port and pin number do you use?

[@msbanda2123]

👍

[@youtubetuts8743]

I followed your step-by-step guide. After changing the the directory to openocd and configuring, i get this: "make: *** No targets specified and no makefile found. Stop. " when i type make command Please help me.

[@ekasusilo]

Check if there was no error during configure stage. That's the reason why the Makefile is missing?

[@user-dh1ye1wc3g]

hello Sir,i meet some issue "Failed to launch GDB: Error finishing flash operation (from target-download)" i already follow your all step,pls help

[@ekasusilo]

Please look at detail error messages. You can turn on raw GDB debugging messages and find out the root cause.

[@user-dh1ye1wc3g]

​@@ekasusilo it says Error: error writing to flash at address 0x08000000 at offset 0x00000000 i search alot website but can't fix that (but thank you anyway)

[@ekasusilo]

@@user-dh1ye1wc3g Is it a custom board of STM32F4 Discovery? If it is STM32F4 Discovery, please note that there are many hardware revision that may need some workaround to get it working

[@ekasusilo]

@@user-dh1ye1wc3g Another thing, you may want to try to flash it with STLink Utility and see if it works. One way of debugging issue related to flashing