⭐ Step by step Transient Thermal Analysis - Cooling of molten Aluminum

[@cadandcaewithhaile8826]

thank you very much. it is very important. keep it up!!!

[@iDESIGNBests]

Thank you, I will

[@arvind7392]

thanks for the video

[@iDESIGNBests]

You're welcome

[@alexchen7704]

Super good video. The only question I have is how did you come up with the enthalpy table?

[@iDESIGNBests]

Hi. Thank you for watching. I found it in one reference.

[@MalluInFrance]

thanks a lot . Can you please tell me how to make the results into 3d ?

[@iDESIGNBests]

Hi. This is a 2D analysis. for 3d results you must run a 3d simulation on a 3d model.

[@ayoubboukannafia4458]

That was so good, keep going I have just a question I have a problem in setting analysis for phase change i wish you can drop your Gmail ?

[@iDESIGNBests]

Hi.Our email address exists in the about section

[@dickoulianovngampo9606]

how to open the ADPL command with ansys 2019 ? please

[@iDESIGNBests]

Hi, do you mean that use APDL scripts in Mechanical

[@dickoulianovngampo9606]

@@iDESIGNBests Is it possible to have your email? I work on the simulation of phase change materials for a heat sink. I am looking for a way to introduce reaction hentalpy into the Ansys transient thermal module