Stihl Farm Boss Carb Tuning

[@ProsperInHealth]

Thanks for taking the time to make this video. I appreciate the brevity.

[@nickdoyle3950]

Were not social to begin w. Respect

[@explorepikespeak]

Dunno if you can give me a clue what's wrong with my 290 Stihl ever since I put a new carb on it (online, aftermarket). The adjustment screws seem to not hold their positions. I get it running fine after agonizing adjustments on all three screws, but then after just a few minutes in the woods it loses power, dies, sometimes. I can adjust the screws again and get it running better, but it'll do the same damned thing again. There is a rubber grommet thing that I think is supposed to hold the screws from turning, but I'm not sure it's making proper contact with the heads of the screws. Did they sell me the wrong carburetor, you think? Or do those rubber grommet hold-downs wear out (it looks to me like it's about an eighth of an inch short, but it's hard to tell. Any easy fixes? Halp!

[@robland6118]

What is that twin turbo set up on that old truck? That thing looks bad ass man. I'd definitely be more interested in that truck. Where are you from buddy?

[@thecarrsgarage2595]

I swore I replied to this. My apologies. That's Little Red. All aluminum L33 5.3. Stock short block. Gapped rings, Tick stage 3 5.3 turbo cam, home ported 799's, hi ram with snake eater 100lb/hr injectors, manual 4l80, mopar 8.75 rear out of my 71'. Currently at 22lbs with a 75 shot till 11 lbs. We're at 7k feet, sw colorado, with the loons. 😂

[@brockheadland1980]

What rpm were you shooting for on the high end

[@SirDadbod]

13500

[@serkankaya1862]

hay man...Why is Turkish not available in translation languages?