Stress Analysis Introduction 4 of 4

[@marchosias2071]

Hello thanks for the video, but could u please elaborate more about how constraints work? So i have a shaft that is not uniform in diameter, on one end its connected to a couple that transmit rotation from gearbox, and on the other end its connected to a bearing, and moment is applied along the shaft going againts the direction of the motor rotation. To simulate this, how do i put the constraint? Thank you very much

[@farida7777777]

The trick is just to constrain it at the coupling point and then apply the moment where the shaft is resisted by the load. That is the easiest way.

[@marchosias2071]

​@@farida7777777i'll try it, thank you!

[@ryanlove2340]

Have you ever played with putting a rib or rim before it gets back to the big part with all the stresss. Just curious how it would react

[@ZbigniewSiwiec]

🍀🍀🍀👍👍👍🌎🌎🇵🇱🇵🇱