Stress Analysis of Planar Truss of Different C/s Area Member using Ansys APDL 2019 R3 in Easy Steps!

[@SimpleRandomKnowledge]

About This Video Hello Guys!! I have made the video on Ansys Mechanical APDL Tutorial where I have Explain How to perform Internal Stress Analysis of a 4 Bar Planar Trusses in very Easy Steps. I hope You Like this video and Subscribe my Channel.

[@ramraokapse4789]

Very good..

[@SimpleRandomKnowledge]

Thank you ❣️

[@PrajYash]

Very well explanation sir ❤️❤️❤️❤️ sir i tried this question on my own but i am getting a msg box showing "Specified forces from the previous F command were applied only to the selected NODAL LOAD set. " And i am unable to understand what to do next. Using 2021 R2 version of ANSYS. Please recommend some Solution. Getting this msg while trying to apply loads at node.

[@SimpleRandomKnowledge]

Watch my video and Follow each steps from start to end thoroughly, if then too problem persist then there might be bug in your version try out with lower version then 2017.

[@PrajYash]

Yes Sir Thank You Sir. It may happen that there will be a bug problem. Any way I will follow your Steps.

[@PrajYash]

Yes Sir Thank You Sir. It may happen that there will be a bug problem. Any way I will follow your Steps.