Normally I can get mine to separate but it is stuck good this time. None of my old tricks work this time.
@thra5herxb12s8 ай бұрын
The clutch sticks on my Morris 1300 engine after being sat for a couple of months. The last time it happened, I started it in gear and drove it up and down the road a few times with my foot still on the clutch pedal, but it still wouldnt budge until I pulled up the handbrake as well to put a bit of extra load on it. I would rather it just didnt happen, so what is the cure, it already had a new clutch plate 2000 miles ago.
@sergesmith28633 жыл бұрын
OK! if this chap would have put it in reverse held the clutch in and set the E break then turned it over this would have broke loose. Did this with my dodge 3500 after siting for two years.
@FluffleValveExpress3 жыл бұрын
We had it every gear and tried staring it with the handbrake on etc, etc. It just wouldn't free off.
@sergesmith28633 жыл бұрын
@@FluffleValveExpress wow that's really stuck.
@Chris-bc3pl6 жыл бұрын
looks like a brand new clutch. How long was truck sitting for?
@FluffleValveExpress6 жыл бұрын
Chris, I made the mistake of running the jet wash over it all to remove muddy crud while the gearbox was off. It sat for two weeks before putting the gearbox back on. Then I found it had glued its self to the flywheel. So it all came out again.
@oilfieldtrucker48685 жыл бұрын
Just like my dad always told me.. nothing like a greasy hole lol
@jasaircraft3 жыл бұрын
What were the symptoms?
@niveklor14562 жыл бұрын
Borderline tight sticky just needed to lube it get it wet
@Codymezger5 жыл бұрын
Bloody ole clutch is stuck did a burn out to fix it didn't work