Suffolk Punch 14SK

[@themowerman]

Good video mate.. the carb float is hard to remove on these

[@alecashworth6230]

Yes, almost impossible without damage to the float pin. I use an ultrasonic bath and carb cleaner with excellent results, leaving the float in situ.

[@alecashworth6230]

Float pin supports, I should have said.

[@themowerman]

@@alecashworth6230 yeah I have broken a carb trying to remove it.. I too use a cleaner.. does a good job

[@williamwalker3837]

What is the difference between the Atco Balmoral 14sk and the Qualcast Classic 35s, apart from the engine. How much would you expect to pay for a good Balmoral.

[@garybrooksbank1930]

How do I remove the height adjuster from this mower

[@kevinparkes8257]

When using the sharpening tool do you run the blades forward and then when backlapping do you run the blades in reverse? Thank you

[@alecashworth6230]

Good question. It would be better as you say to run the blade forward with the sharpening tool attached and then backwards for backlapping. However any direction will do, I feel. My drill is a 1500w Mc Allister and only runs in one direction which means both are backwards for me. Sometimes the sharpening tool is 'ejected' with this method, so I have made an aluminium C bracket to hold it in place (shown in video).

[@kevinparkes8257]

Thanks for the quick reply, picking my mower up later today but as its second hand I was going to sharpen the blades the same way you did but was unsure about the process. Thanks again buddy, great video 👍🏽