Limits and Fits 07 Go No gauge

[@puneetbansal2970]

Sir thank you so much. This 13 min. Lecture cleared all my doubts

[@shahidmeir7379]

Thank you sir . your way of teaching is incredibly effective

[@niyramagdy7346]

Really, thank you, your video is so helpful and you add problems with answers 😊😊

[@zeeshanahmed9719]

Sir your videos are very helpful. Thank you.

[@PrateekSharma016]

Sir why at 07:20, go part is above the no gauge part? Does that we follow this for all snap gauges?

[@shashikantnaikwade6410]

Sir, the position of No Go should be above the ULH (Upper Limit of hole) and Below the LLS

[@bishaldas4370]

For plunger gauge the noGo rectangle will be above the maximum allowance of hole ......mistake in all.🙏🏼

[@PrateekSharma016]

Or is that we take go above for shaft?

[@tarunodoydutta6119]

Where can i find the 6th lecture???

[@varunpratap6785]

last question didnt understand

[@kannanme7835]

thanks sir

[@rajeshdewangan7557]

Sir limi fit ka 6th lecture ni hai

[@a.k.1705]

kzbin.info/www/bejne/sH6VfHmsetuYa9E