Supersonic Flow Over a Wedge Using Ansys Workbench - Adapt the Mesh

[@fluidengineer]

This is from Dr. Rajesh Bhaskaran, Cornell University.

[@nitishkamal6950]

Sir, I have a similar problem. It's from the book "Modern Compressible Flows" by JD Anderson, where we have to compare supersonic flow over wedge and a cone. I'm getting good and close to expected results in case of wedge, I did a similar thing as you did here. But in case of cone, my result is a bit off mark(flow angle beta). I'm also facing some difficulties meshing the tip of cone. Can you give some insight. A short video or a detailed comment would suffice. Thank you.

[@MechTechSimulations]

Dear Nitish, Have you got the expected results?