Surfacing in mach3

[@lutherieamateur2580]

Very useful, I surfaced my new board with it. Thanks a lot.

[@Δημήτρης-η4ρ]

So this will rurface ALL the table right? How about if i have a part on a vice, how can i make it to plunge outside of my part, not in the midle cause i use a 4 cutting tip 10mm mill that cannot plunge. Thank you!!

[@neatpleats11]

Thanks.

[@BluelightGaming1]

Watch the advice you take from this video... There is some I correctly explained settings in here.

[@jnbff10]

what spindle speed?