Yeah it was a good day mate! Was a strong pack out as well 💪🏻
@ianmangham45703 ай бұрын
I got a poxy ebike 42v 10ah lmmfno 😮 🇬🇧, and i love it ,I'd go bonkers on one of these beasts.🇬🇧
@UK_RIDER3654 ай бұрын
Yesssss take em tings of road
@arranbarclay1478 ай бұрын
Rememeber to keep comments respectful and follow our community guidlines.
@markhatton7558 ай бұрын
😂😂
@existenceisintuitive77778 ай бұрын
😂😂
@handlemabiznis5 ай бұрын
Get up lads come on
@thesurronhitta8 ай бұрын
🔥🔥🔥
@borninthewoods4482Ай бұрын
Do You have an inner tube on those Surron’s?
@markhatton755Ай бұрын
Yes mate they are tubed
@borninthewoods4482Ай бұрын
@@markhatton755 do you use rubber inner tubes like the ones on bicycles or anything? I’ve been having bad luck on my e-bike recently and been getting loads of punctures due to tyre pinch and thorns, personally I put it down to modern day thin tyres. I’ve even gone as far to buy armour for the inner tube. Before I spend £4K on a Surron I’d just like to have your review on the tyres inner tubes and how easy it is to take the wheels off/put the wheels on. Thanks
@markhatton755Ай бұрын
@@borninthewoods4482 yeah so there motor cross inner tubes so a fair bit stronger than a pedal bike tube. And thorns don’t get through the tyres on the surron the rubbers nice and think and again they use 19 inch motor cross tyres. One of my pals had a couple of pinch’s but he used to take pressure out also if you run low pressure on these they do like to rip a valve out me personally I’ve had 1 puncture in about 5k miles and that was a nail fully in my tyre 🤦🏼…… I mean if you have the funds available I’d say just get the Ron the fun you have is unmatched by a pedal bike I used to ride mtb and haven’t looked at my pedal bike since owning the Ron 😂
@markhatton755Ай бұрын
@@borninthewoods4482 also the wheels are very easy to take on/off the rear is literally and axle bolt and nut 17mm socket (have to do your chain tensioning every time but that’s just 2 10mm spanner’s) the fronts slightly not but ain’t it’s 2 small Allen key bolts either side then an axle bolt….. tbh the whole bikes very easy to work on