Best demonstration on pee problem ,I did just what you said found the screws ,it came apart easy found tube just as you said ,fixed thanks ,do more videos
@martinschulz93813 жыл бұрын
Good video. I always tape the pee hole shut with a piece of scotch tape to keep the bugs out when the boat is not in use.(Scotch tape come off real easy.) I then zip tie a reminder on the steering wheel so I don't accidentally start the engine with the tape still on.
@tomgia1964 Жыл бұрын
Thanks very much ! 😮 I just replaced my water impeller and still no water coming out and I thought that could be the issue although it is time for that maintenance but I believe that’s my problem too and I’m gonna try that exactly the way you did it and thank you so much👍🏼
@fasteddie7997 Жыл бұрын
I use a peice of weed wacker string to clean out the pisser fitting were the hose meets plastic always clogging up with salt and sand. Works great
@davidfishferrell2 жыл бұрын
I have a Bluewave too. I’ve had boats all my life,Tracktor supply has a water tank 100gallon that cost about $100 that’s the best way to flush your Suzuki,because of how many water pickups it has its best not to use muffs. Also get some salt away and use it every other trip.
@joshuapapas73316 ай бұрын
How on earth did you get to that bottom bolt???
@donalddrago77282 жыл бұрын
Good information. The next time you have several things to point to use a pointer. Something like a pen or pencil.
@slapper22310 ай бұрын
Check the popit valve on the oil pan. That regulates telltale flow a low pressure i(dle)
@ianklatt1868 Жыл бұрын
Hi Thanks for the video. How did you get the bottom nut off Cheers Ian
@danielgerada28752 жыл бұрын
How did you get the bottom bold undone I can't seem to reach it with a spanner or socket thanks
@eastonsales2 жыл бұрын
Take port side cover off
@Fishwheelspdx Жыл бұрын
The worst thing for an outboard it letting it sit for long periods.
@ChewinFat3 жыл бұрын
I have a DF50 and with the dual flow muffs on it won’t pee water out but with regular muffs it works fine idk why it doesn’t like the dual flow muffs
@ChewinFat2 жыл бұрын
@Ironhead Outdoors ya man it’s crazy
@Laserman993 жыл бұрын
Mine was a thermostat that was opening all the way. Need to test in hot water.
@atefrahim31416 жыл бұрын
I have Suzuki 4 strock DF140 when I put the engine cover the engine rpm dropped down and after a while engine shutoff could some one advice me
@goatinamoatproductions69756 жыл бұрын
There is a problem with some Suzie's where there is an exhaust plug on the PORT side down low that corrodes. When it corrodes enough it allows exhaust back in under the hood. When that happens it strangles your engine by feeding it exhaust instead of fresh air. If this is the case for you, then you need to diagnose it and have that area TIG welded.
@thisismecantuseeitsacz58235 жыл бұрын
You need to trade it in for a 250 😂
@seoulbrooks5 жыл бұрын
The maintenance manual states you may have to wait up to 7 minutes for the thermostat to open and then the water will flow through the piss hole. Make sure your thermostat has opened. The same goes for the flushing, make sure it runs long enough to open the thermostat.
@georgematos10865 жыл бұрын
revenge69ful so true !1
@albertjanrijswijk78494 жыл бұрын
The tell tail is a different circuit than the one with the thermostat. It’s separated. As soon as the engine runs, water starts flowing through the tell tail constantly until shut off. Not only when the thermostat opens.
@denisriley88616 жыл бұрын
Water does not come out of the tell tail untill the thermostat opens when engine is up to temp. Some times at idle with the ears on mine will slow to a trickle or shut off momentarily untill the engine warms up then thermostat opens again.
@gordonmcelvany89904 жыл бұрын
Tattle tales work continuously Should show within a 15 seconds.
@tonytownley93644 жыл бұрын
Hi, thanks for the video it’s helpful. One question.. how did you remove that bottom bolt? I’m finding it very difficult to access.
@chadweikman5952 жыл бұрын
pull the side covers... Much easier to access after they are off.
@hassanalbaijan2296 жыл бұрын
Guess pushing an air into the tube port toward into the engine is not a proper idea because you are going to push the possible dirts inside the engine. I had same problems with my dual 115s engines. Solution found easy to force some pressurized water by water ears inside the engine to dissolve the solidified salt blocking the tube and things goes well. Importantly try to do this attempt while engine running within max. 15 sec. if not succeeded, shut off engine and wait for cool and try again for two times.if not succeeding, consult technician.
@easydoz15 жыл бұрын
You still have the boat?
@edwardanguiano52415 жыл бұрын
I do!
@gordonmcelvany89904 жыл бұрын
Doesn't matter what type boat it is.
@saltwaterredfish84565 жыл бұрын
Good video
@mariofaggiano8247 Жыл бұрын
Never run your suzuki on ear muffs you will burn your engine use a tank deep enough to drop the leg of the engine then run it. There is 3 intake water points on my 140hp so i assume all tnese engines are the same. Or you may loose your engine warranty.
@boashna6 жыл бұрын
you know this by now but for others most water will come out of center hub feel it it is hot and pee indicator is just an indicator.. next time pull the black plasticky right where water comes out and clear the derbies in seconds . .it pops out I will do a video on my channel soon
@maxbecker4844 жыл бұрын
I Hit Sand with my prop.. afterwards no Peeing water. When Finger on the hole vor a Minute, it Comes out a little.. Any advice???
@michaelroberts62993 жыл бұрын
That top thing is called a cover!
@damianp1758 Жыл бұрын
It's actually called your outboard's cowling.
@michaelroberts6299 Жыл бұрын
@@damianp1758 you seen that new movie sound of freedom
@josevallejo18224 жыл бұрын
What do you enjoy the most out of your BW 2000 ?
@drumminsonlive91995 жыл бұрын
Good job.
@CaptDavesSportfishing5 жыл бұрын
YA BETTER LEARN MORE
@jinsvi4 жыл бұрын
You could also take it to someone who knows what they are doing.