This goes through how to disassemble and reassemble the transverse leaf spring for a late-model Spitfire, to install the differential mounting plate and housing, and get it all put back together, ready to mount to the differential.
Пікірлер: 14
@alaskadave0072 жыл бұрын
That Was Educational Thank You Mate . DAVID IN IRELAND
@rfraser8752 Жыл бұрын
Thank you for that!
@matthewmcguire65023 жыл бұрын
Excellent video, thank you for posting. Just about to install one of these myself and your video perfectly demonstrates and explains all the missing details in the BPNW video. Well done!
@smellsofbikes3 жыл бұрын
Sure. Their video is great, but the missing step can be frustrating to figure out on your own.
@ronpilchowski98983 жыл бұрын
I'd say the most important thing is to MAKE SURE the 4 holes are Symmetrical to the locating pin . Or the bolts will NEVER line up I learned this the hard way. An extra 10 minutes getting it right Is time well spent
@ronpilchowski98983 жыл бұрын
@@jeremyhank4595 make sure your 4 bolts are symmetrical to the locating knob or your bolts will be miss aligned to the differential... not by Much .. just enough to miss, You can't see down the holes either So do it on the bench I layed the spring upside down Put the bolts through. Then used a small bar across the 2 bolts and measured from the bar to the knob then did the outher side Adjust till they measure the same Then lock the pivot bolt LOL it took me a wail to figure it out A rush job always takes twice as long
@matthewmcguire65023 жыл бұрын
@@ronpilchowski9898 I think the two Jeremy's (Maxton & Hank) are bots or worse. Seems Hank is responding to Maxton about his Instagram pas word hack.
@ronpilchowski98983 жыл бұрын
I just jamed a couple chisels between the leafs to get the plate and bushing in .... MAKE SURE THE 4 BOLT HOLES ARE SYMMETRICAL TO THE LOCATING KNOB ON THE BOTTOM OF THE SPRING ... this is an ounce Of prevention to insure it bolts right up... I did this by myself, I had the spring in and out a couple times to get it right in 100' heat😤😓
@mitchjohnson131911 ай бұрын
Thanks, really useful....did you replace the rubber/silicon buttons as well?
@smellsofbikes11 ай бұрын
I did not, but now wish I had.
@vwboys1 Жыл бұрын
Thanks, would this spring fit into the early style 1969 Spitfire? Excellent explanation about installation of this spring.
@smellsofbikes Жыл бұрын
This is a 1500. My understanding is that they used this spring from 1971 to the end of production. But I think the earlier spitfires used a similar semi-swing-spring, as well. So: I don't know for sure but I bet you'll go through the same process.
@vladimirvelickovich71685 ай бұрын
Where the silicon rubber goes
@smellsofbikes5 ай бұрын
The way I did it didn't involve any rubber. People sometimes machine nylon spacers for between the leaf spring leaves.