synchronizing dual weber carbs

[@MarsGarage333]

Thank you for your video, and im curious which distributor you use.

[@allanbrowne111]

Great video, a big help, thanks.

[@PGGM100]

sometimes the linkage arm needs adjusting, the throttle may open on the same time but may not open one of the throttle all the way. so you need to change were the arms sits.

[@bobsue3639]

I use starting fluid instead of wd40, quicker response to idle changes.

[@anthonysgarden7307]

I run 44 IDFs. Thing that confuses me is the Weber book I have says all the mixture screws must be turned same amount. Other ppl seem to tune each one separately.

[@AlanDavid1955]

how do you like that ignition system you have ?

[@cuda4me1970]

My only question is. Why would you set your tools on the paint? put a rag down first.

[@wiggysshop9890]

Dick Thompson the paint on that car is in really bad shape and needs to be redone. If the paint wasn't so bad I would agree with you that it's a lot better idea to put a rag down first.

[@tellitallnow3914]

Did you already have the engine warm before you took your linkage off your carbs. I have 44mm Weber IDF carbs and I can never start my car cold without being on the throttle. Once everything is warm I can start it just by turning the ignition but never when the motor is cold. Is this normal?

[@wiggysshop9890]

Yes it was warmed up before. If it's cold I have to pump the throttle just a little bit to get it to fire right away because there's no choke.

[@tellitallnow3914]

Thanks so much for your reply. I left you a comment on your Bradly GT video.check it out when ya have the chance.

[@talljr1]

How do you know the correct number to sync the carbs? I had one at 5 and one at 6 using the same tool. How do you know which one is right? Is there a guide that shows the correct number based on carbs or engine setup?

[@wearymicrobe]

Always balance to the reading from the lowest carb stack.

[@DaveLewis60]

Garden hose, duct tape, peeling paint on a Bradley GT. Sano, man!!!

[@Superoldschool74]

Cool Bradley!

[@wiggysshop9890]

Superoldschool74 thanks

[@edmondcotter1014]

👍