Table Foiler Tips and Upgrades

[@altheaboothe7251]

Thank you so much for your videos. I think you should just record your daily work and then edit it all afterwards I learned so much from you

[@glasgowbeck]

Hi Ed I always learn something new from you, thanks

[@gailbuss3912]

Who makes the white crimper you used Ed? Could you give us a link? Thanks a lot. Great video.

[@Ejwoodwork]

Where do I purchase a foil applicator device. I would to buy one. Thx

[@edenhomestead5382]

Do you have a link to the quick crimp tool you used?

[@vanessawilson1704]

When I use the flower (edit: I meant foiler) I find that the tape scrunches up against the wood as the glass comes back on to the table top. Have you got any ideas what's going wrong? Thanks

[@EdsEmporiumArtGlassStudio]

Hi Vanessa, not sure what you mean by flower. But, if the glass is wider than 1/8" or 3mm, then you need a wider roller for the foiler. I may have one in stock.

[@vanessawilson1704]

@@EdsEmporiumArtGlassStudio urgh autocorrect! I meant foiler! When the piece goes through the wheel thing it doesn't crimp quite enough so when the glass comes back on the ledge bit, it catches on the foil. I'm probably not explaining this very well!

[@harcosparky]

OUCH --- What is with that irrtating light flickering?????

[@EdsEmporiumArtGlassStudio]

Reload the video. KZbin when through and updated everyone's videos, I have had one other person ask and that fired it for her. .

[@kirstengriff]

Ed. I couldn't watch your video - the light flickering was driving me nuts 😔

[@eallen62]

Im not sure what you're talking about. We had no other complaints of that.

[@kirstengriff]

Hi. Apologies. I've watched it again and it runs better this morning. My tablet must have been on a go slow😏